LAN89218AQ_samples SMSC, LAN89218AQ_samples Datasheet - Page 108

• Manufacturer Part Number: LAN89218AQ_samples
• Description: Ethernet ICs High Perform Chip 10/100 NonPCI Cntrl
• Manufacturer: SMSC

Specifications of LAN89218AQ_samples

• Ethernet Connection Type: 10BASE-T, 100BASE-TX
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Product: Ethernet Controllers
• Standard Supported: IEEE802.3, IEEE802.3u
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 3 V
• Maximum Operating Temperature: + 85 C
• Package / Case: TQFP-100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Revision 1.3 (02-23-10)
30:28
27:10
BITS
EPC command. This field is used to issue commands to the EEPROM
controller. The EPC will execute commands when the EPC Busy bit is set.
A new command must not be issued until the previous command completes.
This field is encoded as follows:
READ (Read Location): This command will cause a read of the EEPROM
location pointed to by EPC Address. The result of the read is available in
the E2P_DATA register.
EWDS (Erase/Write Disable): After issued, the EEPROM will ignore erase
and write commands. To re-enable erase/write operations issue the EWEN
command.
EWEN (Erase/Write Enable): Enables the EEPROM for erase and write
operations. The EEPROM will allow erase and write operations until the
Erase/Write Disable command is sent, or until power is cycled.
Note: The EEPROM device will power-up in the erase/write-disabled state.
WRITE (Write Location): If erase/write operations are enabled in the
EEPROM, this command will cause the contents of the E2P_DATA register
to be written to the EEPROM location selected by the EPC Address field.
WRAL (Write All): If erase/write operations are enabled in the EEPROM,
this command will cause the contents of the E2P_DATA register to be
written to every EEPROM memory location.
ERASE (Erase Location): If erase/write operations are enabled in the
EEPROM, this command will erase the location selected by the EPC
Address field.
ERAL (Erase All): If erase/write operations are enabled in the EEPROM,
this command will initiate a bulk erase of the entire EEPROM.
RELOAD (MAC Address Reload): Instructs the EEPROM controller to
reload the MAC address from the EEPROM. If a value of 0xA5 is not found
in the first address of the EEPROM, the EEPROM is assumed to be un-
programmed and MAC Address Reload operation will fail. The “MAC
Address Loaded” bit indicates a successful load of the MAC address.
Reserved
Any erase or write operations will fail until an Erase/Write Enable
command is issued.
[30]
0
0
0
0
1
1
1
1
[29]
0
0
1
1
0
0
1
1
High Performance Single-Chip 10/100 Ethernet Controller for Automotive Applications
DESCRIPTION
[28]
DATASHEET
0
1
0
1
0
1
0
1
108
OPERATION
ERASE
WRITE
Reload
EWDS
EWEN
WRAL
READ
ERAL
TYPE
R/W
RO
SMSC LAN89218
DEFAULT
Datasheet
0
-