611073-000 Tyco Electronics, 611073-000 Datasheet - Page 279

• Manufacturer Part Number: 611073-000
• Description: Connector Accessories Adapter Aluminum Alloy Olive Drab Cadmium Over Electroless Nickel
• Manufacturer: Tyco Electronics
• Type: Adapterr

Catalog 1654025
Revised 12-04
www.tycoelectronics.com
Dimensions are in millimeters
and inches unless otherwise
specified. Values in brackets
are U.S. equivalents.
Adhesives
Installation Guide
Molded Parts Pre-coated
with Thermoplastic
Adhesive
Connector Boot
1. Degrease the area of
2. Lightly abrade the
3. Position the boot on the
4. Recover the connector
5. Complete the recovery
6. With a clean cloth,
7. Follow the curing
the adapter to which
the boot will be bonded,
using appropriate
solvent on a paper
tissue or clean cloth. Do
not abrade the adapter
or inside surface of the
boot.
bonding area of the
cable jacket with #320
emery cloth, then wipe
off loose particles with a
tissue or clean cloth
dampened with solvent.
adapter and cable.
Apply heat starting at
the connector end.
end of the boot onto the
adapter and continue
heating until the area is
fully recovered and the
adhesive is properly
melted.
of the boot, continuing
toward the cable end of
the boot until the part is
fully recovered and the
adhesive is properly
melted. The adhesive
should form a bead or
fillet between the cable
and boot when fully
melted.
remove excess
adhesive from all
areas immediately.
conditions outlined in
this guide.
Dimensions are shown for
reference purposes only.
Specifications subject
to change.
(Continued)
Transition
1. Lightly abrade the
2. Center the molded part
3. Apply heat to the center
4. Continue heating each
5. Follow the curing
bonding area of the
cable jacket with #320
emery cloth, then wipe
off loose particles with a
tissue or clean cloth
dampened with solvent.
over the transition area.
of the transition. Recover
one leg of the transition,
moving heat from the
center of the transition
to the adhesive opening
of the leg. Repeat the
procedure on each leg
of the transition.
end until the part is
fully recovered and the
adhesive has properly
melted. The adhesive
should form a bead or
fillet between the cable
and transition when
fully melted.
conditions specified
for “thermosets” in the
“Adhesive/Sealant
Product Characteristics
Table” on pages 5-2 and
5-3.
USA: 1-800-522-6752
Canada: 1-905-470-4425
Mexico: 01-800-733-8926
C. America: 52-55-5-729-0425
South America: 55-11-3611-1514
Japan: 81-44-900-5102
Singapore: 65-4866-151
UK: 44-1793-528171
5-7
5