1893Y-10 IDT, Integrated Device Technology Inc, 1893Y-10 Datasheet - Page 55

• Manufacturer Part Number: 1893Y-10
• Manufacturer: IDT, Integrated Device Technology Inc

Specifications of 1893Y-10

• Lead Free Status / RoHS Status: Not Compliant

7.5.11 10Base-T Operation: Twisted-Pair Transmitter
7.5.12 10Base-T Operation: Twisted-Pair Receiver
7.5.13 10Base-T Operation: Auto Polarity Correction
7.5.14 10Base-T Operation: Isolation Transformer
ICS1893 Rev C 6/6/00
The 10Base-T Twisted-Pair Transmitter is functionally similar to the 100Base-TX Twisted-Pair Transmitter.
The primary differences are in the data rate and signaling, as specified in the ISO/IEC specifications. For
more information, see
The 10Base-T Twisted-Pair Receiver is functionally similar the 100Base-TX Twisted-Pair Receiver. The
primary differences are in the data rate and signaling, as specified in the ISO/IEC specifications. For more
information, see
The ICS1893 can sense and then automatically correct a signal polarity that is reversed on its Twisted-Pair
Receiver inputs. A signal polarity reversal occurs when the input signals on an ICS1893’ s TP_RXP and
TP_RXN pins are crossed or swapped (a problem that can occur during network installation or wiring).
The ICS1893 accomplishes reversed signal polarity detection and correction by examining the signal
polarity of the Normal Link Pulses (NLPs). In 10Base-T mode, an ICS1893 transmits and receives NLPs
when its link is in the Idle state. In 100Base-TX mode, an ICS1893 transmits and receives NLPs during
Auto-Negotiation. An STA can control this feature using the 10Base-T Operations Register bit 18.3, the
Auto Polarity-Inhibit bit. When this bit is logic:
•
•
When an ICS1893 detects a reversed signal polarity on its Twisted-Pair Receiver pins and the Auto
Polarity-Inhibit bit is also logic zero (enabled), the ICS1893 (1) automatically corrects the data stream and
(2) sets its Polarity Reversed bit (bit 18.14) to logic one, to indicate to the STA that this situation exists. Bit
18.14 is a latching high (LH) bit. (For more information on latching high and latching low bits, see
8.1.4.1, “ Latching High Bits”
Note:
The 10Base-T Isolation Transformer operates the same as the 100Base-TX Isolation Transformer. In fact,
in a typical ICS1893 application they are the same unit. For more information, see
“ 100Base-TX Operation: Isolation Transformer”
Zero, the ICS1893 automatically senses and corrects a reversed or inverted signal polarity on its
Twisted-Pair Receive pins (TP_RXP and TP_RXN).
One, the ICS1893 disables this feature.
ICS1893 - Release
The Auto Polarity Correction Function is primarily a 10Base-T operation. However, it is part of the
Twisted-Pair Receiver and is operational during the 100Base-TX auto-negotiation process.
Section 7.4.6, “ 100Base-TX Operation: Twisted-Pair Receiver”
Section 7.4.5, “ 100Base-TX Operation: Twisted-Pair Transmitter”
and
Copyright © 2000, Integrated Circuit Systems, Inc.
All rights reserved.
Section 8.1.4.2, “ Latching Low Bits”
.
55
.)
Chapter 7 Functional Blocks
.
Section 7.4.8,
.
June, 2000
Section