5745919-2 TE Connectivity, 5745919-2 Datasheet - Page 2

• Manufacturer Part Number: 5745919-2
• Description: CABLE CLAMP KIT,SZ 2
• Manufacturer: TE Connectivity
• Type: Cable Clampr

Specifications of 5745919-2

• Rohs Compliant: YES
• Product Type: Backshell/Cable Clamp
• Cable Clamp Type: Two-Piece RFI/EMI Shield
• Shell Size: 2
• Grommets: Without
• Slide Latch: Without
• Thread Size: 4-40
• Id Letter: H
• Shielded: Yes
• Cable Exit Angle: 180°
• Cable Insulation Diameter (mm [in]): 9.53 [0.375]
• Number Of Positions: 15
• Cable Clamp Material: Die Cast
• Shield Plating: Bright Nickel over Copper
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: Individual Kit

3.
3.1.
3.2.
3.3.
3.4.
3.5.
Examination of Product
Dielectric Withstanding Voltage
Insulation Resistance
Shielding Effectiveness
Vibration (b)
Rev A
REQUIREMENTS
Design and Construction
Accessories shall be of the design, construction and physical dimensions specified on the applicable
product drawing.
Materials
A.
B.
C.
D.
E.
Ratings
A.
B.
This is the maximum operating temperature; however, the operating environment used must not
exceed the limits of the cable.
Performance and Test Description
Accessories shall be designed to meet the electrical, mechanical and environmental performance
requirements specified in Figure 1. Results of this are also dependent on the connectors and cables
used for the test. These items must conform to the test requirements in Figure 1.
Test Requirements and Procedures Summary
Test Description
Plastic cable clamps: Thermoplastic, UL 94V-O Rated
Die case cable clamps: Zinc alloy
Assembly hardware: Steel
Crimp ferrules: Copper, brass
Split ring ferrule: Aluminum
Current/Voltage: See Para 3.5.(a)
Operating Temperature:
Meets requirements of
product drawing and
Product Specifications 108-40005
and 108-40011.
1.0 kvac dielectric withstanding
voltage, one minute hold. 1.0
milliampere maximum leakage
current.
5000 megohms minimum initial at
500 volts dc.
Shielding shall attenuate emissions
by the following levels.
No discontinuities greater than 1.0
microsecond.
Frequency MHz
216 – 1000
-55° to 105° C Die cast ca ble clamps
-55° to 85° C Plated plastic cable clamps
30 – 216
Figure 1 (continued)
MECHANICAL
ELECTRICAL
Requirement
Shielding
40 dB
20 dB
Visual, dimensional and
Test between adjacent contacts
and contacts and shields of mated
connector assemblies;
Test Specification 109-29-1.
Test between adjacent contacts
and contacts and shields of mated
connector assemblies; Test
Specification 109-28-4.
Measure shielding effectiveness of
double ended single braid cable;
Test Specification 109-90.
Subject mated connectors to 10-
55-10 Hz traversed in 1 minute at
.06 inches total excursion; 2 hours
in each of 3 mutually
perpendicular planes;
Test Specification 109-21-1.
functional per applicable
inspection plan.
Procedure
108-40032
2 of 6