EP2S60F484C5 Altera, EP2S60F484C5 Datasheet - Page 13

• Manufacturer Part Number: EP2S60F484C5
• Description: IC STRATIX II FPGA 60K 484-FBGA
• Manufacturer: Altera
• Series: Stratix® IIr

Specifications of EP2S60F484C5

• Number Of Logic Elements/cells: 60440
• Number Of Labs/clbs: 3022
• Total Ram Bits: 2544192
• Number Of I /o: 334
• Voltage - Supply: 1.15 V ~ 1.25 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 484-FBGA
• For Use With: 544-1700 - DSP KIT W/STRATIX II EP2S60N544-1697 - NIOS II KIT W/STRATIX II EP2S60N
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -
• Other names: 544-1134; EP2S60F484C5ES

Figure 2–3. Direct Link Connection
Altera Corporation
May 2007
block, DSP block, or IOE output
Direct link interconnect from
left LAB, TriMatrix memory
interconnect
Direct link
to left
Interconnect
LAB Control Signals
Each LAB contains dedicated logic for driving control signals to its ALMs.
The control signals include three clocks, three clock enables, two
asynchronous clears, synchronous clear, asynchronous preset/load, and
synchronous load control signals. This gives a maximum of 11 control
signals at a time. Although synchronous load and clear signals are
generally used when implementing counters, they can also be used with
other functions.
Each LAB can use three clocks and three clock enable signals. However,
there can only be up to two unique clocks per LAB, as shown in the LAB
control signal generation circuit in
enable signals are linked. For example, any ALM in a particular LAB
using the labclk1 signal also uses labclkena1. If the LAB uses both
the rising and falling edges of a clock, it also uses two LAB-wide clock
signals. De-asserting the clock enable signal turns off the corresponding
LAB-wide clock.
Each LAB can use two asynchronous clear signals and an asynchronous
load/preset signal. By default, the Quartus II software uses a NOT gate
push-back technique to achieve preset. If you disable the NOT gate
push-up option or assign a given register to power up high using the
Quartus II software, the preset is achieved using the asynchronous load
Local
Figure
Stratix II Device Handbook, Volume 1
ALMs
2–4. Each LAB's clock and clock
Direct link
interconnect
to right
Direct link interconnect from
right LAB, TriMatrix memory
block, DSP block, or IOE output
Stratix II Architecture
2–5