101-1055 Rabbit Semiconductor, 101-1055 Datasheet - Page 147

• Manufacturer Part Number: 101-1055
• Description: MODULE RABBIT CORE RCM3375
• Manufacturer: Rabbit Semiconductor

Specifications of 101-1055

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM3375
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

E.3 Run a Program
You are now ready to run a sample program or develop a new application. Review these
steps to check your Dynamic C RabbitSys setup before you run a program.
1. Set the compiler to run the application in the fast program execution SRAM by select-
2. Enable separate instruction and data spaces and select “Compile program in RabbitSys
3. Enter the RCM3365 module’s IP address you used in Appendix E.1 by accessing the
E.3.1 Troubleshooting
• If you compiled and ran a sample program with the RabbitSys project option disabled,
• If you were unable to reload the RabbitSys binary file, your RCM3365 does not have
• If Dynamic C returns an error message, check that the RCM3365 is powered correctly
User’s Manual
ing
Options > Compiler
user mode” from the Dynamic C
Dynamic C
IP Connection.” You must also enter “32023” for the Control Port and the default login
values of “admin” and “password.”
you may have overwritten the RabbitSys binary file. Use the serial programming cable
to connect programming header J1 on the RCM3365 to your PC COM port to reload
the RabbitSys binary file via the Dynamic C
menu.
the firmware to support Dynamic C RabbitSys and cannot be used with Dynamic C
RabbitSys.
— the red
mounted on the Prototyping Board and the AC adapter is plugged in. Ensure that the
RCM3365 module is firmly and correctly installed in its connectors on the Prototyping
Board.
Code and BIOS in Flash, Run in RAM
NOTE: The rdiscover utility will not work when the RCM3365 is connected directly to a
PC, notebook, or workstation via an Ethernet crossover cable unless the PC, notebook,
or workstation is running a DHCP server.
CORE
Options > Project Options > Communications
LED on the Prototyping Board should be lit when the RCM3365 is
menu.
Options > Project Options > Compiler
Compile > Reload RabbitSys binary
from the Dynamic C
menu to select “Use TCP/
Options > Project
menu.
141