SAB 82525 N V2.2 Infineon Technologies, SAB 82525 N V2.2 Datasheet - Page 43

• Manufacturer Part Number: SAB 82525 N V2.2
• Description: IC CONTROLLER HSCX PLCC-44
• Manufacturer: Infineon Technologies

Specifications of SAB 82525 N V2.2

• Controller Type: Serial Communications Controller (SCC)
• Interface: Serial
• Voltage - Supply: 4.75 V ~ 5.25 V
• Current - Supply: 8mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 44-PLCC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: SAB82525NV2.2XT; SAB82525NV22XK; SP000063649; SP000084997

4.4 DMA Interface
The HSCX comprises a 4-channel DMA interface for fast and effective data transfers.
For both serial channels, a separate DMA Request Output for Transmit (DRQT) and receive
direction (DRQR) as well as a DMA Acknowledgement (DACK) input is provided.
The HSCX activates the DRQ line as long as data transfers are needed from/to the specific
FIFO (level triggered demand transfer mode of DMA controller).
It’s the responsibility of the DMA controller to perform the correct amount of bus cycles. Either
read cycles will be performed if the DMA transfer has been requested from the receiver, or write
cycles if DMA has been requested from the transmitter. If the DMA controller provides a DMA
acknowledge signal (input to the HSCX’s DACK pin), each bus cycle implicitly selects the top
of the specific FIFO and neither address (via A0-A6) nor chip select need to be supplied (I/O
to Memory transfers). If no DACK signal is supplied, normal read/write operations (providing
addresses) must be performed (memory to memory transfers).
The HSCX deactivates the DRQ line immediately after the last read/write cycle of the data
transfer has started.
Table 4
Special Condition Interrupts
SPECIAL CONDITION INTERRUPTS
Layer 2-Specific *
RSC
PCE
Internal Timer
TIN
External Pin
CSC
Semiconductor Group
Receive Status Change
Protocol Error
Timer Interrupt
(ISTA)
CTS Status Change
(EXIR)
Activated only if the "Auto" operating mode has been selected
via MODE register)
43
Activated after a status change of the opposite
stations receiver has been detected (Receiver
Ready/Receiver Not Ready) due to the
reception of a
– RR frame, if receiver was not ready, or
– RNR frame, if receiver was ready.
Activated if a protocol violation has been
detected due to the reception of
– an S-, or I-frame with incorrect N(R),
– an S-frame containing an I-field.
Activated if the internal timer and repeat
counter has been expired (see description of
TIMR register in chapter 8).
* Only activated if enabled by setting the CIE
bit in the CCR2 register.
SAB 82525
SAB 82526
SAF 82525
SAF 82526