PIC16LF1827-I/MV Microchip Technology Inc., PIC16LF1827-I/MV Datasheet - Page 200

• Manufacturer Part Number: PIC16LF1827-I/MV
• Description: 7 KB Flash, 384 bytes RAM, 32 MHz Int. Osc, 16 I/0, Enhanced Mid Range Core, nan
• Manufacturer: Microchip Technology Inc.

Specifications of PIC16LF1827-I/MV

• A/d Inputs: 12-Channel, 10-Bit
• Comparators: 2
• Cpu Speed: 8 MIPS
• Eeprom Memory: 256 Bytes
• Input Output: 16
• Interface: CAN/I2C/SPI/UART/USART
• Memory Type: Flash
• Number Of Bits: 8
• Package Type: 18-pin SOIC
• Programmable Memory: 7K Bytes
• Ram Size: 384 Bytes
• Speed: 32 MHz
• Timers: 4-8-bit, 1-16-bit
• Voltage, Range: 1.8-5.5 V

PIC16(L)F1826/27
REGISTER 23-3:
DS41391D-page 200
bit 7
Legend:
R = Readable bit
u = Bit is unchanged
‘1’ = Bit is set
bit 7
bit 6
bit 5
bit 4
bit 3-0
Note 1:
MDCHODIS
R/W-x/u
Narrowed carrier pulse widths or spurs may occur in the signal stream if the carrier is not synchronized.
MDCHODIS: Modulator High Carrier Output Disable bit
1 = Output signal driving the peripheral output pin (selected by MDCH<3:0>) is disabled
0 = Output signal driving the peripheral output pin (selected by MDCH<3:0>) is enabled
MDCHPOL: Modulator High Carrier Polarity Select bit
1 = Selected high carrier signal is inverted
0 = Selected high carrier signal is not inverted
MDCHSYNC: Modulator High Carrier Synchronization Enable bit
1 = Modulator waits for a falling edge on the high time carrier signal before allowing a switch to the
0 = Modulator Output is not synchronized to the high time carrier signal
Unimplemented: Read as ‘0’
MDCH<3:0> Modulator Data High Carrier Selection bits
1111 = Reserved. No channel connected.
1000 = Reserved. No channel connected.
0111 = CCP4 output (PWM Output mode only)
0110 = CCP3 output (PWM Output mode only)
0101 = CCP2 output (PWM Output mode only)
0100 = CCP1 output (PWM Output mode only)
0011 = Reference Clock module signal
0010 = MDCIN2 port pin
0001 = MDCIN1 port pin
0000 = V
MDCHPOL
R/W-x/u
low time carrier
•
•
•
MDCARH: MODULATION HIGH CARRIER CONTROL REGISTER
SS
W = Writable bit
x = Bit is unknown
‘0’ = Bit is cleared
MDCHSYNC
R/W-x/u
U-0
—
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
R/W-x/u
(1)
R/W-x/u
MDCH<3:0>
 2011 Microchip Technology Inc.
(1)
R/W-x/u
R/W-x/u
bit 0