Z8622912SSG Zilog, Z8622912SSG Datasheet - Page 45

• Manufacturer Part Number: Z8622912SSG
• Description: IC CCD W/2ND I2C ADD 18-SOIC
• Manufacturer: Zilog
• Type: Video Decoderr

Specifications of Z8622912SSG

• Applications: Set-Top Boxes, TV
• Voltage - Supply, Digital: 4.75 V ~ 5.25 V
• Mounting Type: Surface Mount
• Package / Case: 18-SOIC (7.5mm Width)
• Processor Series: Z8622x
• Core: Z80
• Data Bus Width: 8 bit
• Program Memory Type: CGROM
• Program Memory Size: 3.7 B
• Maximum Clock Frequency: 12 MHz
• Operating Supply Voltage: 4.75 V to 5.25 V
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply, Analog: -
• Lead Free Status / Rohs Status: Details

ZiLOG
DEMONSTRATION PROGRAMS
Communicating with the Z86229
Communications with the Z86229 is accomplished using its
serial communications interface. Through hardware setup,
this interface can be configured into either of two serial pro-
tocols, I
provided in the Serial Communications Interface section
(page 22) and are not dealt with here. It is assumed that the
user is familiar with the serial protocol requirements.
Note:
I
The Z86229 is configurable as an I
communicates with the Z86229 through its parallel port.
These programs are not intended as examples of how to pro-
gram the application, but are only provided as a means of
illustrating the serial control process and the capability of
the Z86229.
The three programs available are titled IICO, SCRIPTI, and
XDSCAP. These programs have been compiled and run sat-
isfactorily with the Z86229 in a test board. Compiled ver-
sions are available on disk. Contact your local ZiLOG sales
office for further information on these programs.
IICO Program
This program sends one byte to the Z86229 without check-
ing the status of the READY bit. The program returns the
contents of the Serial Status (SS) Register after the com-
mand has been entered. When the program is active the
screen displays:
IIC Command Byte >
The user may enter any valid one-byte command such as
FBh (Reset) or 00h (NOP) and then hit the ENTER key. The
screen then displays the byte entered and the SS register
contents read:
IIC Byte = 00
IIC Status = 83h
The text above shows that the NOP command was entered.
The SS register contents, 83h, indicates that the RDY, FLD,
2
C Operation
In the following descriptions <ENTER> means press the
Enter key.
2
C or SPI. The details of hardware setup have been
2
C slave device. The PC
and LOCK bits are High. This condition indicates that the
serial port is ready for further input, that the input video sig-
nal was in Field 1 at the time the status was read, and that
the part is operating in video-lock mode.
The IICO program is exited by entering a Control+C (^C)
character.
For example, entering the following single byte commands
would generate the following:
The commands that control most of the display capability
of the Z86229 are all one-byte commands which can be en-
tered using the IICO program. These commands are tabu-
lated below for convenience.
General Commands
Caption/Text Display Mode Commands
CPTX Command Code