DPX2MAA106PA106P33B0001FO ITT, DPX2MAA106PA106P33B0001FO Datasheet - Page 17

• Manufacturer Part Number: DPX2MAA106PA106P33B0001FO
• Manufacturer: ITT

Specifications of DPX2MAA106PA106P33B0001FO

• Body Orientation: Straight
• Gender: PIN/PIN
• Termination Style: Crimp
• Total Number Of Contacts: 106/106POS
• Number Of Contact Rows: 8/8
• Housing Material: Aluminum Alloy
• Contact Material: Copper Alloy
• Mounting Style: Panel
• Contact Plating: Gold
• Product Height (mm): 50.8mm
• Product Length (mm): 78.99mm
• Lead Free Status / Rohs Status: Not Compliant

Coaxial Cable Assembly
www.ittcannon.com
ARINC 404
Dimensions shown in inch (mm)
Specifications and dimensions subject to change
ITT Cannon recommends resistance soldering for all
solder contacts, particularly for RF cable where
excessive heat will damage the dielectric. Wires
For Codes A, B, C, D, and E
1. Cut cable evenly. Trim to dimensions as shown
2. Remove inner contact from coaxial assembly
3. Push inner contact back into coaxial assembly.
4. Pull outer conductor over coaxial shell, and
5. Apply shrink sleeving after assembly.
For Codes I and J
1. Cut cable evenly. Trim to dimensions as shown
2. Comb braid, tin conductor and remove flux.
3. Remove solder pot cover. Insert cable and
4. Replace solder pot cover and solder braid to
5. Apply shrink sleeving after assembly.
For Codes K
1. Cut cable evenly. Trim to dimensions as shown
2. Unscrew cap and remove spacer and inner
3. Push cable through center of cap and spacer.
4. Solder inner. contact to inner conductor of
5. Push inner contact back into coaxial shell as-
6. Separate outer conductor of cables into two
7. Attach on pigtail to each end of cap strip and
8. Apply shrink sleeving after assembly.
For Codes Z and AA
1. Cut cable evenly. Trim to dimensions as shown
2. Solder inner conductor to coaxial contact
3. Pull sleeve forward over braid and solder
4. Solder sleeve to coaxial body.
on page 60. Care should be taken not to injure
the conductor or dielectric.
and solder it to inner conductor of cable.
solder.
on page 60. Care should be taken not to injure
the conductor or dielectric.
solder conductor to contact. The dielectric
should butt against contact solder pot.
ferrule.
on page 60. Care should be taken not to injure
the conductor or dielectric.
contact from coaxial assembly.
cable.
sembly and attach cap.
pigtails 180˚ apart.
solder.
on page 60. Care should be taken not to injure
the conductor or dielectric.
through side slot in coaxial with outer sleeve
pushed back on cable.
through holes in sleeve.
should be pre-tinned. Bushing, endbells, and junc-
tion shells (where applicabe) must be slipped over
wire bundles before soldering is started. Consult
CONDUCTOR
59
OUTER
CAP STRIP
OUTER CONDUCTOR
JACKET
OUTER SLEEVE
4.
CAP
3.
2.
COAXIAL SHELL
CONTACT
INNER CONDUCTOR
REAR INSULATOR
SHELL
ASSY
factory for types not shown. The mechanical steps
in wiring coaxials described below.
SPACER
INNER CONTACT
FRONT INSULATOR
INNER CONDUCTOR
DPX Solder
INNER CONTACT