C500-NC222-E Omron, C500-NC222-E Datasheet - Page 3

• Manufacturer Part Number: C500-NC222-E
• Description: 27C0061
• Manufacturer: Omron

Specifications of C500-NC222-E

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Rohs Compliant: No

Caution Make sure not to duplicate the Unit No. of Drivers when setting up. Starting communications
Caution When connecting HA/LA Drivers to your computer, make sure that the Driver’s Unit No. are
Caution If the 12 bit Absolute Encoder Alarm Reset has been performed, make sure to reset the origi-
1. When using multiple axis communications, set the Unit No. of each Driver before connecting to your
2. For multiple axis communications, set the Unit No. in the range of 1 to E (14). Never use Unit No. “0.”
3. With H/L and UE, there is no Unit No. setting as multiple axis communications do not apply to this
1. When using multiple axis communications, if one of the Driver’s Unit No. was specified as “0” or is
2. If the User Parameter Window displays “-----” in the Unit No. column, this means that the Unit No. is
1. If the 12 bit Absolute Encoder Alarm Reset is performed, the volume of multiple rotation is automati-
2. 12 bit Absolute Encoder Alarm Reset corrects and resets the following encoder errors from your
Starting Up Multiple Axis Communications
Parameter Transfer to Drivers
Absolute Encoder Setup
Safety Precautions
computer.
model.
With HA/LA, set the Driver’s Unit No. using the Parameter Unit.
With UT, set the Driver’s Unit No. using the rotary switch located on the front of each Driver.
the same as the Unit No.of another Driver, this may damage the Drivers and/or the computer.
yet to be specified. In this case, the unspecified parameter can not be transferred to a Driver.
cally reset to “Zero.” Starting the mechanical system without resetting the original point will alter this
position and can be very dangerous.
computer:
A. 81 Encoder backup alarm
A. 82 Encoder checksum error
with you computer with duplicate Unit Nos. may result in damage to Drivers and/or the com-
puter.
all correct or yet to be specified before transferring parameters to the Drivers. Transferring an
incorrect Unit No. to Drivers may result in damage to Drivers and/or the computer.
nal point. Failure to do so may result in personal injury or damage to the machines.