C8051T601-GMR Silicon Laboratories Inc, C8051T601-GMR Datasheet - Page 57

• Manufacturer Part Number: C8051T601-GMR
• Description: MCU 8-Bit C8051T60x 8051 CISC 8KB EPROM 1.8V/3V 14-Pin QFN EP T/R
• Manufacturer: Silicon Laboratories Inc

Specifications of C8051T601-GMR

• Package: 14QFN EP
• Device Core: 8051
• Family Name: C8051T60x
• Maximum Speed: 25 MHz
• Ram Size: 256 Byte
• Program Memory Size: 8 KB
• Operating Supply Voltage: 1.8|3 V
• Data Bus Width: 8 Bit
• Program Memory Type: EPROM
• Number Of Programmable I/os: 8
• Interface Type: I2C/SMBus/UART
• Operating Temperature: -40 to 85 °C
• Number Of Timers: 3

C8051T600/1/2/3/4/5/6
12. Voltage Regulator (REG0)
C8051T600/1/2/3/4/5/6 devices include an internal voltage regulator (REG0) to regulate the internal core
supply to 1.8 V from a V
supply of 1.8 to 3.6 V. Two power-saving modes are built into the regulator to
DD
help reduce current consumption in low-power applications. These modes are accessed through the
REG0CN register (SFR Definition 12.1). Electrical characteristics for the on-chip regulator are specified in
Table 8.5 on page 34.
If an external regulator is used to power the device, the internal regulator may be put into bypass mode
using the BYPASS bit. The internal regulator should never be placed in bypass mode unless an
external 1.8 V regulator is used to supply V
. Doing so could cause permanent damage to the
DD
device.
Under default conditions, when the device enters STOP mode the internal regulator will remain on. This
allows any enabled reset source to generate a reset for the device and bring the device out of STOP mode.
For additional power savings, the STOPCF bit can be used to shut down the regulator and the internal
power network of the device when the part enters STOP mode. When STOPCF is set to 1, the RST pin or
a full power cycle of the device are the only methods of generating a reset.
Rev. 1.2
57