ATxmega128B3 Atmel Corporation, ATxmega128B3 Datasheet - Page 24

• Manufacturer Part Number: ATxmega128B3
• Manufacturer: Atmel Corporation

Specifications of ATxmega128B3

• Flash (kbytes): 128 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 1
• Uart: 1
• Segment Lcd: 100
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 4
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

4.11
4.12
4.13
8291A–AVR–10/11
Device ID and Revision
JTAG Disable
I/O Memory Protection
Each device has a three-byte device ID. This ID identifies Atmel as the manufacturer of the
device and the device type. A separate register contains the revision number of the device.
It is possible to disable the JTAG interface from the application software. This will prevent all
external JTAG access to the device until the next device reset or until JTAG is enabled again
from the application software. As long as JTAG is disabled, the I/O pins required for JTAG can
be used as normal I/O pins.
Some features in the device are regarded as critical for safety in some applications. Due to this,
it is possible to lock the I/O register related to the clock system, the event system and the
advanced waveform extensions. As long as the lock is enabled, all related I/O registers are
locked and they can not be written from the application software. The lock registers themselves
are protected by the configuration change protection mechanism. For details refer to
tion Change Protection” on page
12.
Atmel AVR XMEGA B
”Configura-
24