SAM9RL64 Atmel Corporation, SAM9RL64 Datasheet - Page 121

• Manufacturer Part Number: SAM9RL64
• Manufacturer: Atmel Corporation

Specifications of SAM9RL64

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 118
• Ext Interrupts: 118
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 2
• Uart: 5
• Ssc: 2
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 6
• Adc Resolution (bits): 10
• Adc Speed (ksps): 220
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 64
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

5.3.3
ARM DDI0198D
Multi-cycle access timing
If non zero wait state memory is used for TCM, then the DRWAIT/IRWAIT signals
are used to wait the ARM926EJ-S. The wait information for a data cycle is pipelined so
that the value of DRWAIT/IRWAIT pertains to the following data cycle, which
corresponds to the request cycle for the first data cycle. If there is no active TCM access
then the value on DRWAIT/IRWAIT is ignored. This allows the wait signals to be
generated speculatively.
Figure 5-6 shows how the speculative generation of IRWAIT can be used to generate a
single wait state for every ITCM access.
In cycle T1, IRWAIT is asserted but no request is made.
In cycle T2, IRWAIT is asserted and a request is made.
In cycle T3, IRWAIT is deasserted indicating that the access to A will complete in the
following cycle.
In cycle T4, IRWAIT is asserted and a request is made. The access to A completes.
In cycle T5, IRWAIT is deasserted indicating that the access to B will complete in the
following cycle.
In cycle T6, IRWAIT is asserted. No request is made. The access to B completes.
The logic required for the above example corresponds to the two-state state machine
shown in Figure 5-7 on page 5-14.
Copyright © 2001-2003 ARM Limited. All rights reserved.
IRADDR
IRWAIT
Figure 5-6 Generating a single wait state for ITCM accesses using IRWAIT
IRCS
IRRD
CLK
T1
T2
A
T3
T4
Tightly-Coupled Memory Interface
B
I(A)
T5
T6
I(B)
5-13