5-2007615-5 TE Connectivity, 5-2007615-5 Datasheet - Page 7

• Manufacturer Part Number: 5-2007615-5
• Manufacturer: TE Connectivity

Specifications of 5-2007615-5

• Solder Ball: Tin-Silver
• Product Height: 5mm
• Number Of Positions: 200
• Vacuum Cover: With
• Contact Type: Socket
• Contact Base Material: Copper Alloy
• Contact Finish: Gold (30) over Nickel (50)
• Connector Style: Receptacle
• Housing Material: Thermoplastic - GF
• Stack Height (mm [in]): 15.00 [0.591], 17.00 [0.669], 18.00 [0.709], 20.00 [0.787], 25.00 [0.984], 30.00 [1.181]
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: Hard Tray

4.
4.1.
4.2.
4.3.
4.4.
Rev B
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to
confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing and
this specification.
Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production per Figure 2. Test group 1 requires 10 connector pairs
terminated to LLCR PCB. Test group 2 requires 5 connector pairs terminated to LLCR PCB and a
minimum of 3 connector pairs terminated to continuity PCB. Test group 3 requires 3 loose piece
connector pairs. Test group 4 requires 5 connector pairs terminated to LLCR PCB and a minimum
of 3 connector pairs terminated to continuity PCB. Mated connectors shall be held together with
standoffs and fasteners. Test group 5 requires 5 connector pairs terminated to .062 inch minimum
thick LLCR PCB. Test group 6 requires 30 connectors terminated to continuity PCB. Mated
connectors shall be held together with standoffs and fasteners. Test group 7 requires 2 connector
pairs terminated to special serial current test PCB.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figure 2.
108-2143
7 of 8