TMP86xy46NG Toshiba, TMP86xy46NG Datasheet - Page 157

• Manufacturer Part Number: TMP86xy46NG
• Manufacturer: Toshiba

Specifications of TMP86xy46NG

• Package: SDIP42
• Rom Types (m=mask,p=otp,f=flash): M/P/F
• Rom Size: 8/16/32
• Ram Size: 512/512/1K
• Driver Led: 19
• Driver Lcd: -
• Spi/sio Channels: 1
• Uart/sio Channels: 1
• I2c/sio Channels: -
• High-speed Serial Output: -
• Adc 8-bit Channels: -
• Adc 10-bit Channels: 8
• Da Converter Channels: -
• Timer Counter 18-bit Channel: -
• Timer Counter 16-bit Channel: 1
• Timer Counter 8-bit Channel: 2
• Motor Channels: -
• Watchdog Timer: Y
• Dual Clock: Y
• Clock Gear: -
• Number Of I/o Ports: 33
• Power Supply (v): 4.5 to 5.5

14.1 Operating mode
14. OTP operation
14.1.2.2 Program Writing using a General-purpose PROM Programmer
Note 1: For the setting method, refer to each description of PROM programmer.
Note 2: When setting MCU to the adaptor or when setting the adaptor to the PROM programmer, set the first
Note 3: The TMP86PM46NG does not support the electric signature mode.
1. Recommended OTP adaptor
2. Setting of OTP adaptor
3. Setting of PROM programmer
4. Writting
Make sure to set the data of address area that is not in use to FFH.
pin of the adaptor and that of PROM programmer socket matched. If the first pin is conversely set,
MCU or adaptor or programmer would be damaged.
of 12±0.5V to pin 9(A9) of the address. Don’t use the signature.
If PROM programmer uses the signature, the device would be damaged because of applying voltage
a. Set PROM type to TC571000D/AD.
b. Data transmission ( or Copy) (Note 1)
c. Setting of the program address (Note 1)
BM11188 for TMP86PM46NG
Set the switch (SW1) to "N" side.
mode: MCU mode and PROM mode. When you write the data of ROM for mask ROM prod-
ucts, the data shuold be transferred (or copied ) from the address for MCU mode to that for
PROM mode before writing operation is executed. For the applicable program areas of MCU
mode and PROM mode are different, refer to TMP86PM46NG" Figure 14-1 Program Mem-
ory Area ".
Write and verify according to the above procedure "Setting of PROM programmer".
Vpp: 12.75 V (high-speed program writing mode)
The PROM of TMP86PM46NG is located on different address; it depends on operating
Example: In the block transfer (copy) mode, executed as below.
32KB ROM capacity: 08000~0FFFFH → 00000~07FFFH
16KB ROM capacity: 0C000~0FFFFH → 04000~07FFFH
8KB ROM capacity : 0E000~0FFFFH → 06000~07FFFH
4KB ROM capacity : 0F000~0FFFFH → 07000~07FFFH
Start address: 0000H (When 16 KB ROM capacity, start address is 4000H.
End address: 7FFFH
When 4KB ROM capacity, start address is 7000H.)
When 8 KB ROM capacity, start address is 6000H.
Page 146
TMP86PM46NG