BTS5461SF Infineon Technologies, BTS5461SF Datasheet - Page 10

• Manufacturer Part Number: BTS5461SF
• Manufacturer: Infineon Technologies

Specifications of BTS5461SF

• Packages: PG-DSO-36
• Channels: 4.0
• Channel Mix: 2*4,5mohm+2*11mohm
• Led Mode: Yes
• Cranking Mode: No
• Pwm Engine Integrated: No

Absolute Maximum Ratings (cont’d)
T
(unless otherwise specified)
Pos.
4.1.20 Current through serial output pin
Limp Home Pin
4.1.21 Voltage at limp home input pin
4.1.22 Current through limp home input pin
Temperatures
4.1.23 Junction temperature
4.1.24 Dynamic temperature increase while switching
4.1.25 Storage temperature
ESD Susceptibility
4.1.26 ESD susceptibility HBM
1) Not subject to production test, specified by design.
2) Device is mounted on an FR4 2s2p board according to Jedec JESD51-2,-5,-7 at natural convection; The product
3) In accordance to AEC Q100-012 and AEC Q101-006.
4) R
5) No protection mechanism available. Inverse current needs to be limited by external circuitry to prevent overheating.
6) Over current protection is a protection feature. Operation in over current protection is considered as “outside” normal
7) Pulse shape represents inductive switch off: I
8) ESD resistivity, HBM according to ANSI/ESDA/JEDEC JS-001-2010
Note: Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
Note: Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
Data Sheet
j
= -40 to +150 °C; all voltages with respect to ground
(chip+package) was simulated on a 76.4 x 114.3 x 1.5 mm board with 2 inner copper layers (2 x 70 µm Cu, 2 x 35 µm Cu).
Where applicable, a thermal via array under the package contacted the first inner copper layer.
operating range. Protection features are not designed for continuous repetitive operation.
I
is the internal resistance of the load dump pulse generator.
maximum rating conditions for extended periods may affect device reliability.
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are
not designed for continuous repetitive operation.
Parameter
other pins incl. OUT vs. GND
1)
OUT pins vs. VS
D(t)
= I
D
(0) × (1 - t / t
10
Symbol
I
V
I
T
Δ
T
V
SO
LHI
j
T
stg
LHI
ESD
j
pulse
); 0 < t < t
min.
-2.0
-0.3
-0.75
-2.0
-40
–
-55
-4
-2
Limit Values
pulse
max.
2.0
5.5
0.75
2.0
150
60
150
4
2
Electrical Characteristics
SPOC - BTS5461SF
Unit Conditions
mA
V
mA –
°C
K
°C
kV
Rev. 1.0, 2011-11-17
t
–
t
–
–
–
HBM
–
–
≤ 2 min.
≤ 2 min.
8)