TM100SV_02L04 TORiSAN, TM100SV_02L04 Datasheet - Page 14

• Manufacturer Part Number: TM100SV_02L04
• Description: LCD_Module
• Manufacturer: TORiSAN

Tottori SANYO Electric Co., Ltd.
1. Instructions for safety
(1) Please do not disassemble or modify LCD module to avoid the possibility of electric
(2) Please be careful in handling of LCD module with broken glass.
(3) Please do not touch the fluid flown out of broken display glass.
(4) Please make secure connection of Lamp connector.
(5) Lamp contains mercury inside. Please follow regulations or rules established by local
(6) Please be careful to electric shock.
2. Instructions for designing
(1) Mounting of LCD
(2) Mounting of LCD
(3) Polarity of power supply for Lamp
PRECAUTIONS (INSTRUCTIONS FOR SAFE AND PROPER USE)
shock, damage of electronic components, scratch at display surface and invasion of
foreign particles. In addition, such activity may result in fire accident due to burning of
electronic component.
LCD module disassembled or modified by customer is out of warranty.
display surface has the plastic film attached, which prevents dispersion of glass
pieces, however touching broken edge will injure your fingers. Also Lamp (Cold
Cathode Fluorescent Lamp) is made of glass, therefore please pay attention in the
same way.
and then wash it with water. If the fluid should get in eyes, wash eyes immediately
with pure water for more than 15 minutes and then consult the doctor.
connector on inverter circuit securely. Poor connection may cause smoke or fire
accident due to high voltage in circuit. If connection may not be secure, please switch
off the power supply for LCD module and Lamp and then make secure connection.
connector.
autonomy at its disposal.
in operation mode, touching them will cause electric shock.
installation onto system. The used screws should have proper dimensions.
is not warped or twisted, to achieve good display quality.
panel for installation onto system. If must be press it down that please leave it from
the Bezel opening area more than 2mm.
connected correctly at assembling (i.e. high voltage side is connected to high voltage
side and low voltage side is connected to low voltage side). Since longer Lamp cable
may cause insatiable start-up of Lamp and reduction of brightness, please make
cable short as much as possible.
When the display glass breaks, please pay attention not to injure your fingers. The
If the fluid should stick to hand or clothes, wipe off with soap or alcohol immediately
Please make sure that Lamp connector from LCD module is connected with output
Please do not make connection with another connector than recommended mating
Before handling LCD module, please switch off the power supply.
Since high voltage is applied to Lamp terminal, cable, connector and inverter circuit
Please fix LCD module at all mounting flanges shown in this specification for
Furthermore, designing of mounting parts should be adequate so that LCD module
Please give careful consideration in designing so that each polar of cable should be
Please give careful consideration in designing which doesn't press down a Touch
TM100SV-02L04
Ver.1
Page
13/17