TM100SV_02L04 TORiSAN, TM100SV_02L04 Datasheet - Page 16

• Manufacturer Part Number: TM100SV_02L04
• Description: LCD_Module
• Manufacturer: TORiSAN

Tottori SANYO Electric Co., Ltd.
(2) Protection against dust and stain
(3) Protection film for display surface
(4) Contamination of display surface
(5) Water drop on LCD surface
(6) Please make sure that LCD module is not warped or twisted at installation into
(7) Mechanical stress
(8) Pressure to display surface
(9) Protection against scratch
(10) Plugging in of connector
(11) Handling of Lamp cable and FPC (Flexible Printed Circuit)
(12) Switching off before plugging in connector
to avoid getting dust or stain on display surface.
avoid getting scratch or dust. To remove film, please pick up its edge with dull-head
tweezers or cellophane tape at first and then remove film gradually taking more than
3 seconds. If film is removed quickly, static electricity may be generated and may
damage semiconductors or electronic components.
softly with cotton swab or clean cloth
water drop, please wipe it off with cotton swab or soft cloth immediately, otherwise
display surface will be deteriorated.
system. Even temporary warp or twist may be the cause for failure.
module. Such stress may cause break of display glass and Lamp or may be the
cause for failure.
may cause scratches at surface or may be the cause of failure.
tools. In addition, please do not put heavy or hard material on display surface, and do
not stack LCD modules. Touch panel at front surface can be easily scratched.
plugging in or out, because strong stress may damage the inside connection. At
plugging in connector, place LCD module on the flat surface and hold the backside of
connector on LCD module. Please make sure that connector is plugged in correctly.
Insecure connection may be the cause for failure during operation.
system and LCD module at installing LCD module into system.
of cable may be damaged consequently.
supply and input signals of driving system meet the specified power sequence.
LCD module should be handled in circumstance as clean as possible.
It is recommended to wear fingerstalls or ductless and soft gloves before handling
It is recommended to remove protection film at nearly final process of assembling to
When display surface of Touch panel is contaminated, please wipe the surface
Please do not leave LCD module with water drop. When the display surface gets
If water gets in inside of LCD module, circuit may be damaged.
Please be careful not to apply strong mechanical stress like drop or shock to LCD
Please be careful not to apply strong pressure to display surface. Such pressure
Please be careful not to hit, press or rub the display surface with hard material like
Please be careful not to apply strong stress to connector part of LCD module at
In addition, please be careful not to put the connecting cable between cabinet of
Please be careful not to pull or scratch Lamp cable, because Lamp or soldered part
Also FPC should not be pulled or scratched.
Please make sure that power is switched off before plugging in connector.
If power is on at plugging in or out, circuit of LCD module may be damaged.
When LCD is switched on for test or inspection, please make sure that power
TM100SV-02L04
Ver.1
Page
15/17