TM100SV_02L04 TORiSAN, TM100SV_02L04 Datasheet - Page 15

• Manufacturer Part Number: TM100SV_02L04
• Description: LCD_Module
• Manufacturer: TORiSAN

Tottori SANYO Electric Co., Ltd.
(4) Designing of power supply circuit for Lamp
(5) Heat radiation
(6) Noise on power line
(7) Power sequence
(8) Absolute maximum rating
(9) Protection for power supply
(10) Protection against electric shock
(11) Protection cover and cut-off filter for ultraviolet rays
3. Instructions for use and handling
(1) Protection against Static electricity
second. The shorter time may not start up Lamp. The driving inverter circuit is
recommended to be the type which Lamp current can be controlled.
current under high temperature and insatiable start-up of Lamp under low
temperature.
Therefore, designing to radiate heat like radiation slits at cabinet is recommended to
meet the specified operating temperature range for LCD module.
and abnormal display. To avoid it, spike noise should be suppressed below VDD +/-
200mVp-p. (In any case, absolute maximum rating should be kept.)
signals of system, testing equipment, etc. meet the recommended power sequence.
It shows the maximum that cannot be exceeded.
in circuit. Please make system design so that absolute maximum rating is not
exceeded even if ambient temperature, input signal and components are varied.
depending on usage condition of system. Fuse installed on LCD module should be
never modified. Any modification to make the function of fuse ineffective may cause
burning or break of printed wiring board or other components at circuit trouble.
Please make design not to expose or be accessible to such high voltage parts to
avoid electric shock.
to use transparent protection cover over display surface to avoid scratches and
invasion of dust and water. In addition, when LCD module is exposed to direct sun
light for long time, use of cut-off filter for ultraviolet rays is also recommended. Please
be careful not to get condensation.
module should be handled on conductive mat by person grounded with wrist strap
etc. to avoid getting static electricity. Please be careful not to generate static
electricity during operation.
Please design the circuit so that high voltage output can be kept for more than 1
The type which voltage is controlled is not recommended, because it may cause big
Lamp generates heat at lighting and causes temperature rise inside system.
Spike noise contained in power line causes abnormal operation of driving circuit
Before LCD module is switched on, please make sure that power supply and input
Absolute maximum rating specified in this specification has to be kept in any case.
Exceeding it may cause burning or non-recoverable break of electronic components
Please study to adapt protection for power supply against trouble of LCD module,
High voltage is applied to Lamp connector, inverter circuit and Lamp at lighting.
When LCD module is used under severe condition like outdoor, it is recommended
C-MOS LSI and semiconductors are easily damaged by static discharge. LCD
TM100SV-02L04
Ver.1
Page
14/17