wm8804geds-v Wolfson Microelectronics plc, wm8804geds-v Datasheet - Page 41

• Manufacturer Part Number: wm8804geds-v
• Description: 1 1 Digital Interface Transceiver With Pll
• Manufacturer: Wolfson Microelectronics plc

Table 49 S/PDIF Status Register
Table 50 Interrupt Mask Control Register
w
Production Data
REGISTER
ADDRESS
SPDSTAT
(read-only)
REGISTER
ADDRESS
INTMASK
R12
0Ch
R10
0Ah
BIT
5:4
0
1
2
3
6
BIT
7:0
Where the INT_N has been asserted by an update signal (UPD_NON_AUDIO, UPD_CPY_N,
UPD_REC_FREQ, UPD_UNLOCK or UPD_DEEMPH) the S/PDIF Status Register (SPDSTAT) can
be interrogated to establish the updated value of the flag.
The interrupt and update signals used to generate INT_N can be masked at the users discretion. The
MASK register bit (Table 50) prevents flags from asserting INT_N and from updating the Interrupt
Status Register.
REC_FREQ
AUDIO_N
DEEMPH
UNLOCK
MASK[7:0]
LABEL
PCM_N
CPY_N
LABEL
[1:0]
DEFAULT
DEFAULT
00000000
--
-
-
-
-
-
Audio Status Flag
Recovered channel status bit-1.
0 = Data word represents audio PCM samples.
1 = Data word does not represent audio PCM samples.
Non-PCM Flag
Indicates that non-audio code (defined in IEC-61937) has
been detected.
0 = Sync code not detected.
1 = Sync code detected – received data is not audio PCM.
Non-Copyright Flag
Recovered Channel Status bit-2.
0 = Copyright is asserted for this data.
1 = Copyright is not asserted for this data.
De-emphasis Flag
Recovered Channel Status bit-3.
0 = Copyright is asserted for this data.
1 = Copyright is not asserted for this data.
Recovered Frequency Flag
Indicates recovered S/PDIF clock frequency:
00 = 192kHz
01 = 96kHz or 88.2kHz
10 = 48kHz or 44.1kHz
11 = 32kHz
Unlock Flag
Indicates that the S/PDIF Rx clock recovery circuit is
unlocked.
0 = Locked onto incoming S/PDIF stream.
1 = Not locked onto the incoming S/PDIF stream.
Interrupt Mask Enable
When a flag is masked, it does not update the Interrupt Status
Register or cause an INT_N interrupt to be asserted.
0 = unmask, 1 = mask.
MASK[0] = mask control for UPD_UNLOCK
MASK[1] = mask control for INT_INVALID
MASK[2] = mask control for INT_CSUD
MASK[3] = mask control for INT_TRANS_ERR
MASK[4] = mask control for UPD_NON_AUDIO
MASK[5] = mask control for UPD_CPY_N
MASK[6] = mask control for UPD_DEEMPH
MASK[7] = mask control for UPD_REC_FREQ
DESCRIPTION
DESCRIPTION
PD, Rev 4.5, March 2009
WM8804
41