wm8400 Wolfson Microelectronics plc, wm8400 Datasheet - Page 111

• Manufacturer Part Number: wm8400
• Description: Wolfson Audioplustm Hi-fi Audio Codec And Power Management Unit For Mobile Multimedia
• Manufacturer: Wolfson Microelectronics plc

w
Pre-Production
Details of the GPIO implementation are shown below. In order to avoid GPIO loops if a GPIO is
configured as an output the corresponding input is disabled, as shown in Figure 48 below.
Figure 48 GPIO Pad
The GPIO register, i.e. latch structure, is shown in Figure 49 below. The de-bounce Control fields
GPIOn_DEB_ENA determine whether the signal is de-bounced or not. (Note that TOCLK (via
SYSCLK) needs to be present in order for the debounce circuit to work.) The polarity bits
GPIO_POL[7:0] control whether an interrupt is triggered by a logic 1 level (for GPIO_POL[n] = 0) or a
logic 0 level (for GPIO_POL[n] = 1). The latch will cause the interrupt to be stored until it is reset by
writing to the Interrupt Register. The latched signal is processed by the IRQ circuit, shown in Figure
47 above. The interrupt status bits can be read at any time from Register R18 (see Table 68) and are
reset by writing a “1” to the applicable bit in Register R18.
Note that the interrupt behaviour is driven by level detection (not edge detection). Therefore, if an
input remains asserted after the interrupt register has been reset, then the interrupt event will be
triggered again even though no transition has occurred. If edge detection is required, this may be
implemented as described in the following paragraphs.
Figure 49 GPIO Function
Three typical scenarios are presented in the following Figure 50, Figure 51 and Figure 52. The
examples are:
•
•
•
Latch a GPIO input (Figure 50)
Debounce and latch a GPIO input (Figure 51)
Use the GPIOn_POL bit to implement an IRQ edge detect function (Figure 52)
PP, April 2009, Rev 3.0
WM8400
111