V23814-U1306-M136 INFINEON [Infineon Technologies AG], V23814-U1306-M136 Datasheet - Page 22

• Manufacturer Part Number: V23814-U1306-M136
• Description: PAROLI Tx AC, 1.6 Gbit/s
• Manufacturer: INFINEON [Infineon Technologies AG]

Assembly
On the next pages are some figures to assist the customer in designing his printed circuit
board (PCB).
and receiver modules and
solder pads on a customer PCB that are necessary to mount the modules on this PCB.
Keeping the tolerances for the PCB given in
properly attach the PAROLI transmitter and receiver module to the PCB.
Attachment to the customer PCB should be done with four M2 screws torqued to
0.25 Nm +0.05 Nm (see
to 4 mm plus the thickness b of the customer PCB.
Special care must be taken to remove residues from the soldering and washing process
which can impact the mechanical function. Avoid the use of aggressive organic solvents
like ketones, ethers, etc. Consult the supplier of the PAROLI modules and the supplier
of the solder paste and flux for recommended cleaning solvents.
The following common cleaning solvents will not affect the module: deionized water,
ethanol, and isopropyl alcohol. Air-drying is recommended to a maximum temperature
of 150°C. Do not use ultrasonics.
During soldering, heat must be applied to the leads only, to ensure that the case
temperature never exceeds 150°C. The module must be mounted with a hot-air or hot-
bar soldering process using a SnPb solder type, e.g. Sn62Pb36Ag2, in accordance with
ISO 9435.
Data Sheet
Figure 10
Figure
shows the mechanical dimensions of the PAROLI transmitter
Figure 11
10, cross section B-B). The screw length a should be 3
to
Figure 13
22
Figure 11
give the dimensions of the holes and
to
Figure 13
V23814-U1306-M136
V23815-U1306-M136
is required to
Assembly
2002-05-14