73K212AL TDK [TDK Electronics], 73K212AL Datasheet - Page 4

• Manufacturer Part Number: 73K212AL
• Description: V.22, V.21, Bell 212A, Bell 103 Single-Chip Modem with Integrated Hybrid
• Manufacturer: TDK [TDK Electronics]

73K222BL
V.22, V.21, Bell 212A, Bell 103
Single-Chip Modem with Integrated Hybrid
FUNCTIONAL DESCRIPTION
(continued)
PARALLEL BUS INTERFACE
Four 8-bit registers are provided for control, option
select and status monitoring. These registers are
addressed with the AD0, AD1, and AD2 multiplexed
address lines (latched by ALE) and appear to a control
microprocessor as four consecutive memory locations.
Two control registers and the tone register are
read/write memory. The detect register is read only and
cannot be modified except by modem response to
monitored parameters.
SPECIAL DETECT CIRCUITRY
The special detect circuitry monitors the received
analog signal to determine status or presence of carrier,
call-progress tones, answer tone and weak received
signal (long loop condition). An unscrambled mark
request signal is also detected when the received data
out of the DPSK demodulator before the descrambler
has been high for 165.5 ms ± 6.5 ms minimum. The
appropriate detect register bit is set when one of these
conditions changes and an interrupt is generated for all
purposes except long loop. The interrupts are disabled
(masked) when the enable interrupt bit is set to 0.
DTMF GENERATOR
The DTMF generator will output one of 16 standard
tone pairs determined by a 4-bit binary value and TX
DTMF mode bit previously loaded into the tone register.
Tone generation is initiated when the DTMF mode is
selected using the tone register and the transmit enable
(CR0 bit D1) is changed from 0 to 1.
4