HT48R70A-1_07 HOLTEK [Holtek Semiconductor Inc], HT48R70A-1_07 Datasheet - Page 16

• Manufacturer Part Number: HT48R70A-1_07
• Description: I/O Type 8-Bit MCU
• Manufacturer: HOLTEK [Holtek Semiconductor Inc]

Input/Output Ports
There are 56 bidirectional input/output lines in the
microcontroller, labeled from PA to PG, which are
mapped to the data memory of [12H], [14H], [16H],
[18H], [1AH], [1CH] and [1EH] respectively. All of these
I/O ports can be used for input and output operations.
For input operation, these ports are non-latching, that is,
the inputs must be ready at the T2 rising edge of
instruction MOV A,[m] (m=12H, 14H, 16H, 18H, 1AH,
1CH or 1EH). For output operation, all the data is
latched and remains unchanged until the output latch is
rewritten.
Each I/O line has its own control register (PAC, PBC,
PCC, PDC, PEC, PFC, PGC) to control the input/output
configuration. With this control register, CMOS output or
Schmitt trigger input with or without pull-high resistor
structures can be reconfigured dynamically (i.e.
on-the-fly) under software control. To function as an in-
put, the corresponding latch of the control register must
write 1 . The input source also depends on the control
register. If the control register bit is 1 , the input will
read the pad state. If the control register bit is 0 , the
contents of the latches will move to the internal bus. The
latter is possible in the read-modify-write instruction.
For output function, CMOS is the only configuration.
These control registers are mapped to locations 13H,
15H, 17H, 19H, 1BH, 1DH and 1FH.
Rev. 2.10
Input/Output Ports
16
After a chip reset, these input/output lines remain at high
levels or floating state (depending on the pull-high op-
tions). Each bit of these input/output latches can be set
or cleared by SET [m].i and CLR [m].i (m=12H, 14H,
16H, 18H, 1AH, 1CH or 1EH) instructions.
Some instructions first input data and then follow the
output operations. For example, SET [m].i , CLR
[m].i , CPL [m] , CPLA [m] read the entire port states
into the CPU, execute the defined operations
(bit-operation), and then write the results back to the
latches or the accumulator.
Each line of port A has the capability of waking-up the
device.
There is a pull-high option available for all I/O lines (port
option). Once the pull-high option of an I/O line is se-
lected, the I/O line have pull-high resistor. Otherwise,
the pull-high resistor is absent. It should be noted that a
non-pull-high I/O line operating in input mode will cause
a floating state.
The PB0 and PB1 are pin-shared with BZ and BZ signal,
respectively. If the BZ/BZ option is selected, the output
signal in output mode of PB0/PB1 will be the PFD signal
generated by Timer/Event Counter 0 overflow signal.
The input mode always remain in its original functions.
Once the BZ/BZ option is selected, the buzzer output
signals are controlled by the PB0 data register only.
HT48R70A-1/HT48C70-1
August 7, 2007