FT240XS-U FTDI, FT240XS-U Datasheet - Page 24

• Manufacturer Part Number: FT240XS-U
• Description: USB Interface IC USB to Parallel FIFO IC SSOP-24
• Manufacturer: FTDI

Specifications of FT240XS-U

• Rohs: yes
• Tradename: X-Chip

6.3 USB Bus Powered with Power Switching Configuration
Figure 6.4 Bus Powered with Power Switching Configuration
A requirement of USB bus powered applications, is when in USB suspend mode the application draws a
total current of less than 2.5mA. This requirement includes external logic. Some external logic has the
ability to power itself down into a low current state by monitoring the PWREN# signal. For external logic
that cannot power itself down in this way, the FT240X provides a simple but effective method of turning
off power during the USB suspend mode.
Figure 6.4 shows an example of using a discrete P-Channel MOSFET to control the power to external
logic. A suitable device to do this is an International Rectifier (www.irf.com) IRLML6402, or equivalent. It
is recommended that a “soft start” circuit consisting of a 1kΩ series resistor and a 0.1μF capacitor is used
to limit the current surge when the MOSFET turns on. Without the soft start circuit it is possible that the
transient power surge, caused when the MOSFET switches on, will reset the FT240X or the USB host/hub
controller. The soft start circuit example shown in Figure 6.4 powers up with a slew rate of
approximaely12.5V/ms. Thus supply voltage to external logic transitions from GND to +5V in
approximately 400 microseconds.
As an alternative to the MOSFET, a dedicated power switch IC with inbuilt “soft-start” can be used. A
suitable power switch IC for such an application is the Micrel (www.micrel.com) MIC2025-2BM or
equivalent.
With power switching controlled designs the following should be noted:
i)
ii) Set the Pull-down on Suspend option in the internal FT240X MTP memory.
iii) The PWREN# pin should be used to switch the power to the external circuitry.
iv) For USB high-power bus powered applications (one that consumes greater than 100mA, and up
v) PWREN# gets its VCC from VCCIO. For designs using 3V3 logic, ensure VCCIO is not powered
The external logic to which the power is being switched should have its own reset circuitry to
automatically reset the logic when power is re-applied when moving out of suspend mode.
to 500mA of current from the USB bus), the power consumption of the application must be set in
the Max Power field in the internal FT240X MTP memory. A high-power bus powered application
uses the descriptor in the internal FT240X MTP memory to inform the system of its power
requirements.
down using the external logic. In this case use the +3V3OUT.
SHIELD
5
1
2
3
4
Copyright © 2013 Future Technology Devices International Limited
100nF
GND
10nF
Ferrite
Bead
47pF
VCC
+
P Channel Power
10k
GND
MOSFET
4.7uF
47pF
FT240X USB 8-BIT FIFO IC Datasheet
GND
27R
27R
Document No.: FT_000626 Clearance No.:
0.1uF
1k
100nF
USBDM
VCC
USBDP
3V3OUT
RESET#
VCCIO
FT240X
0.1uF
Switched 5V Power to
CBUS5
External Logic
PWREN#
Version 1.3
FTDI# 259
24