CY8CKIT-050B Cypress Semiconductor, CY8CKIT-050B Datasheet - Page 21

no-image

CY8CKIT-050B

Manufacturer Part Number
CY8CKIT-050B
Description
Development Boards & Kits - ARM PSoC 5LP Development Kit
Manufacturer
Cypress Semiconductor
Datasheet

Specifications of CY8CKIT-050B

Rohs
yes
Product
Development Kits
Tool Is For Evaluation Of
PSoC 5LP
Core
ARM Cortex M3
Interface Type
RS-232, USB
Operating Supply Voltage
9 V/12 V
4.2.1.4
4.2.1.5
4.2.2
4.2.2.1
CY8CKIT-050 PSoC® 5LP Development Kit Guide, Doc. # 001-65816 Rev. *E
The board provides the ability to measure analog and digital power separately. To measure power at
a single point, rather than at analog and digital separately, remove the resistor R23 to disconnect the
analog regulator from powering the Vdda and short Vdda and Vddd through R30. Now, the net
power can be measured at the J10 jumper similar to the digital power measurement. To switch
repeatedly between R23 and R30, moving around the zero-ohm resistors can be discomforting.
Hence, a J38 (unpopulated) is provided to populate a male 3-pin header and have a shorting jumper
in the place of R23/R30.
While measuring device power, make the following changes in the board to avoid leakage through
other components that are connected to the device power rails.
AC/DC Adaptor Specifications
Use adaptors with the following specifications:
Some recommended part numbers include EPSA120100U-P5P-EJ (CUI Inc.) and LTE12W-S2 (Li
Tone Electronics Co. Ltd).
Battery Specifications
Use batteries with the following specifications:
Some recommended part numbers include 6LR61XWA/1SB (Panasonic), MN1604 (Duracell), and
6LR61 (Energizer).
Programming Interface
This kit allows programming in two modes:
On-board Programming Interface
The on-board programmer interfaces with your PC through a USB connector, as shown in
Figure
Disconnect the RS-232 power by disconnecting R58. An additional jumper capability is available
as J37 if you populate it with a 2-pin male header.
Disconnect the potentiometer by disconnecting J30.
Ground the boost pins if boost operation is not used by populating R1, R28, and R29. Also make
sure R25 and R31 are not populated.
Input voltage: 100 to 240 VAC, 50 Hz to 60 Hz, 1A
Output voltage: 12 VDC, 1A
Power output: 12 W
Polarization: Positive center
Certification: CE certified
Battery size: 6LR61 (9 V)
Output voltage: 9 VDC
Type: Non-rechargeable alkaline consumer batteries
RoHS status: RoHS compliant
Lead free status: Pb-free
Using the on-board programming interface
Using the JTAG/SWD programming interface with a MiniProg3
4-1.
Hardware
21

Related parts for CY8CKIT-050B