EVB-B1+ WIZnet, EVB-B1+ Datasheet - Page 16

• Manufacturer Part Number: EVB-B1+
• Description: Development Boards & Kits - ARM W3150A+EVAL BOARD BASED ON AVR
• Manufacturer: WIZnet

Specifications of EVB-B1+

• Rohs: yes
• Product: Evaluation Boards
• Interface Type: RS-232, SPI
• Operating Supply Voltage: 3.3 V, 5 V
• Data Bus Width: 8 bit
• Dimensions: 50 mm x 40 mm
• Processor Series: ATmega128

2.3. Quick Start
After the confirming the Package of EVB B/D, test EVB B/D in the order shown below.
① Confirm the testing environment. Refer to
② Confirm the network information of Test PC as the following
③ Install AX1 on Test PC. Refer to
④ After the execution of serial terminal program (like Hyperterminal), set up the properties as the
⑤ Turn on the power switch(SW2) of EVB B/D
-
-
-
Source IP Address : 192.168.0.3
Gateway IP Address : 192.168.0.1
Subnet Mask : 255.255.255.0
Check lighting on power LED(D3) of EVB B/D when powering on
Check if LEDs of D1 and D2 blink three times by turns.
Check if Text LCD display of EVB B/D outputs in the way shown in <Fig 2.5> and shown in <Fig
2.6> on the Terminal Program
Connect test PC to EVB B/D using UTP cross cable directly.
Connect test PC to EVB B/D using serial cable directly.
Connect 12V power adaptor to EVB B/D
following.
After the completion of terminal setup, connect to EVB B/D and wait.
Following items should be checked upon power on
© Copyright 2006 WIZnet Co., Inc. All rights reserved.
Properties
Bits Per second(Baud Rate)
Data Bits
Stop Bits
Parity
Flow Control
<Table 2-1 : Terminal Properties Setting>
<Fig 2.5 : EVB B/D Text LCD Display>
Chapter 2.2.2.1
Chapter 2.1
Setting Value
57600 bps
8 Bits
1 Bit
No
None
6