EVB-B1+ WIZnet, EVB-B1+ Datasheet - Page 26

• Manufacturer Part Number: EVB-B1+
• Description: Development Boards & Kits - ARM W3150A+EVAL BOARD BASED ON AVR
• Manufacturer: WIZnet

Specifications of EVB-B1+

• Rohs: yes
• Product: Evaluation Boards
• Interface Type: RS-232, SPI
• Operating Supply Voltage: 3.3 V, 5 V
• Data Bus Width: 8 bit
• Dimensions: 50 mm x 40 mm
• Processor Series: ATmega128

2.4.2.3.
Loopback TCP Client Application is an application that loops back any file and packet data through TCP
channel connected with “AX1” Program of Test PC
After running the “AX1” on the server, set any channel of W3150A
type using [Manager>>Channel Config] menu of EVB B/D.
When setting up the “Loopback TCP Client” Application type of EVB B/D, set the Server IP as the IP Address
of the Test PC and set Server Port as the waiting Server Port Number(3000). Refer to
After setting up EVB B/D is complete, exit from the manager program and run EVB Test Application. If EVB
B/D is connected to “AX1” successfully, loop back the desired data. Refer to “AX1 Manual Vx.x.pdf”
2.4.2.4.
Loopback UDP Application is an application that loops back any file and packet data through UDP Channel
connected with “AX1” Program of Test PC. First of all, to test Loopback UDP, set up any channel of W3150A
as “Loopback UDP” Application Type using [Manager>>Channel Config] Menu of EVB B/D.
In setting up “Loopback UDP” Application type, set Source Port as any value. Here, it’s set with 3000. Refer
to
After EVB B/D setup is over, loop back desired data with IP Address and UDP Source Port of EVB B/D using
menu or Icon related to UDP.
Refer to “AX1 Manual Vx.x.pdf”.
Chapter 2.4.1.2
Loopback TCP Client
Loopback UDP
© Copyright 2006 WIZnet Co., Inc. All rights reserved.
<Fig 2.18: Loopback TCP Client>
<Fig 2.19: Loopback UDP Test>
+
as “Loopback TCP Client” application
Chapter
2.4.1.2.
+
16