LM5067MM-2/NOPB National Semiconductor, LM5067MM-2/NOPB Datasheet - Page 2

• Manufacturer Part Number: LM5067MM-2/NOPB
• Description: IC CTLR NEG HOTSWAP A/R 10MSOP
• Manufacturer: National Semiconductor
• Type: Hot-Swap Controllerr

Specifications of LM5067MM-2/NOPB

• Applications: General Purpose
• Internal Switch(s): No
• Voltage - Supply: -9 V ~ -80 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 10-TFSOP, 10-MSOP (0.118", 3.00mm Width)
• For Use With: LM5067EVAL - NEGATIVE HOT SWAP / INRUSH CURRE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: LM5067MM-2TR

www.national.com
Connection Diagrams
Ordering Information
Pin Descriptions
MSOP-10
LM5067MWX-1
Order Number
LM5067MMX-1
LM5067MMX-2
LM5067MW-1
LM5067MM-1
LM5067MM-2
1
2
3
4
5
6
7
8
Pin #
SO-14
10
1
3
4
5
6
8
9
UVLO/EN
10-Lead MSOP
SENSE
Fault Response
TIMER
Name
OVLO
GATE
PWR
VCC
VEE
Auto Restart
Auto Restart
Top View
Latch Off
Latch Off
Latch Off
Latch Off
Gate drive output Connect to the external N-channel MOSFET’s gate.
Timing capacitor An external capacitor at this pin sets the insertion time delay and the fault
Negative supply
Positive supply
Power limit set
Under-voltage
Current sense
Over-voltage
Description
(Note
lockout
lockout
input
input
input
7)
Package Type
MSOP-10
30030902
SO-14
Applications Information
Connect to system ground through a resistor. Connect a bypass capacitor
to VEE. The voltage from VCC to VEE is nominally 13V set by an internal
zener diode.
An external resistor divider from the system input voltage sets the under-
voltage turn-on threshold. The enable threshold at the pin is 2.5V above
VEE. An internal 22 µA current source provides hysteresis. This pin can be
used for remote enable and disable.
An external resistor divider from the system input voltage sets the over-
voltage turn-off threshold. The disable threshold at the pin is 2.5V above
VEE. An internal 22 µA current source provides hysteresis.
An external resistor at this pin, in conjunction with the current sense resistor
(R
MOSFET.
Connect to the system negative supply voltage (typically -48V).
timeout period. The capacitor also sets the restart timing of the LM5067-2.
The voltage across the current sense resistor (R
to this pin. If the voltage across R
and the fault timer activates.
S
), sets the maximum power dissipation in the external series pass
2
NSC Package Drawing
MUB10A
M14B
S
reaches 50 mV the load current is limited
14-Lead SOIC
Top View
1000 Units on Tape and Reel
3500 Units on Tape and Reel
1000 Units on Tape and Reel
3500 Units on Tape and Reel
1000 Units on Tape and Reel
50 Units per Rail
S
) is measured from VEE
Supplied As
30030964