TLE6232GP Infineon Technologies, TLE6232GP Datasheet
TLE6232GP
Specifications of TLE6232GP
SP000308875
SP000691110
TLE6232GP
TLE6232GPNT
TLE6232GPT
TLE6232GPT
TLE6232GPTR
TLE6232GPXT
Available stocks
Related parts for TLE6232GP
TLE6232GP Summary of contents
Page 1
Smart Six Channel Low-Side Switch Features Short Circuit Protection Over-temperature Protection Over-voltage Protection 16 bit Serial Data Input and Diagnos- tic Output (2 bit/ch. acc. SPI protocol) Direct Parallel Control of all six Chan- nels for ...
Page 2
RESET GND VS PRG IN1 IN2 as Ch.1 IN3 as Ch.1 IN4 as Ch.1 IN5 as Ch.1 IN6 as Ch SPI Interface 16 bit SCLK CS V2.3 VS FAULT short to ground 6 Output 6 Control Buffer ...
Page 3
Pin Description Pin Symbol 1 GND Ground 2 NC not connected 3 OUT5 Power Output Channel not connected 5 OUT1 Power Output Channel 1 6 IN5 Input Channel 5 7 IN1 Input Channel Supply ...
Page 4
Maximum Ratings for T = – 40°C to 150°C j Parameter Supply Voltage Continuous Drain Source Voltage (OUT1...OUT8) Input Voltage, All Inputs and Data Lines Operating Temperature Range Storage Temperature Range Output Current per Channel (see el. characteristics) Single pulse ...
Page 5
Electrical Characteristics Parameter and Conditions V = 4 ° 150 °C ; Reset = (unless otherwise specified) 1. Power Supply, Reset 2 Supply Voltage Supply Current Supply ...
Page 6
Electrical Characteristics cont. Parameter and Conditions V = 4 ° 150 °C ; Reset = (unless otherwise specified) 5. Diagnostic Functions Open Load Detection Voltage Short to ...
Page 7
Description of the Power Stages 4 low side power switches for nominal currents (power stages OUT1 to OUT4). Con- trol is possible by input pins or via SPI. For T switches is below 500m . 2 low ...
Page 8
The effect of the integrated under-voltage detection is similar to the effect of an external reset at pin Reset (except low current consumption): - locks all power switches regardless of their input signals - clears the fault registers - resets ...
Page 9
SPI Signal Description CS - Chip Select. The system microcontroller selects the TLE 6232 GP by means of the CS pin. Whenever the pin logic low state, data can be transferred from the µC and vice versa. ...
Page 10
SPI Interface Power Stages 1...6 SCON_REG CS SCLK CS SCK SI Shift Register SO SPI Communication A SPI communication starts with a SPI instruction (SI control word) sent from the controller to TLE 6232 GP. Simultaneously the device sends the ...
Page 11
SCON_REG: 8-bit (1 byte) length for serial control of the outputs (serial data bits) - DIAG_REG: 16-bit (2 byte) length. Contains the diagnostic information (2 bits per chan- nel), a common over-temperature bit and a common fault bit. Registers ...
Page 12
On a reading access the bit pattern of the data byte at the SPI input SI will be ignored. The first SO byte sent out simultaneously by the TLE 6232 GP always contains the common fault bit, the over-temperature bit ...
Page 13
Serial/Parallel Control of the Power Stages 1...6 (SPI-Instructions: WR_MUX, RD_MUX, WR_SCON, RD_SCON) The following table shows the truth table for the control of the power stages 1...6. The register MUX_REG prescribes parallel or serial control of the power stages. The ...
Page 14
Description of the SPI Registers (SPI Instructions: RD_DIAG) Register: DIAG_REG1 7 6 ST7 ST6 State of FFH Reset: Access by Read only Controller: Bit Name 7-6 DIA4 5-4 DIA3 3-2 DIA2 1-0 DIA1 Note: This byte is always clocked out ...
Page 15
CS SCLK MSB Figure 2: Serial Interface CS 0 SCKH t lead SCLK Figure 3: Input Timing Diagram 0.7 V SCLK t valid SO ...
Page 16
80% 20% Figure 5: Power Outputs Timing is valid for resistive load with parallel and serial control. Rising edge of chip select initiates the switching Application Circuits µC e.g. ...
Page 17
Parallel SPI Configuration Engine Management Application TLE 6232 GP in combination with TLE 6240 GP (16-fold switch) for relays and general pur- pose loads and TLE 6220 GP (quad switch) to drive the injector valves. This arrangement covers the numerous ...
Page 18
Package and Ordering Code (All dimensions in mm) PG-DSO 36 TLE 6232 GP Green Product (RoHS compliant) To meet the world-wide customer requirements for environmentally friendly products and to be com- pliant with government regulations the device is available as ...
Page 19
Revision History Version Date V2.2 -> 18.11.2009 V2.3 V2.1 -> V2.2 V2.0 -> 05.04.2007 V2.1 V1.2 -> 05.03.2007 V2.0 V1.2 08.10.2003 V2.3 Changes Package changed to PG-DSO-36 Ordering Code / Q-Nr. removed Layout Changes, correct green package name implemented P-DSO- ...
Page 20
... Infineon Technologies Office. Infineon Technologies components may be used in life-support devices or systems only with the express written approval of Infineon Technologies failure of such components can reasonably be expected to cause the failure of that life-support device or system or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body or to support and/or maintain and sustain and/or protect human life ...