MAX749ESA+ Maxim Integrated Products, MAX749ESA+ Datasheet - Page 11

• Manufacturer Part Number: MAX749ESA+
• Description: IC SUPPLY LCD BIAS ADJ 8-SOIC
• Manufacturer: Maxim Integrated Products

Specifications of MAX749ESA+

• Applications: LCD Display
• Current - Supply: 60µA
• Voltage - Supply: 2 V ~ 6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

A 22µF, 30V surface-mount (SMT) tantalum output filter
capacitor typically maintains 100mVp-p output ripple
when generating -24V at 40mA from a 5V input. Smaller
capacitors, down to 10µF, may be used for light loads
in applications that can tolerate higher output ripple.
Surface-mount capacitors are generally preferred
because they lack the inductance and resistance of the
leads of their through-hole equivalents.
A 22µF tantalum capacitor in parallel with a 0.1µF
ceramic normally provides sufficient bypassing. Mount
the 0.1µF capacitor very close to the IC. Larger
capacitors may be needed if the incoming supply has
high impedance. Less bypass capacitance is accept-
able if the circuit is run off a low-impedance supply.
Begin prototyping with a large bypass capacitor; when
the circuit is working, reduce the bypass to the smallest
value that gives good results. Although bench power
supplies have low impedance at DC, they often have
high impedance at the frequencies used by switching
DC-DC converters.
The effective series resistance (ESR) of both the
bypass and filter capacitors affects efficiency. Best per-
formance is obtained by doubling up on the filter
capacitors or using low-ESR types.
The smallest low-ESR SMT capacitors currently avail-
able are Sprague 595D series, which are about half the
size of competing products. Sanyo OS-CON organic
semiconductor through-hole capacitors also exhibit low
ESR, and are especially useful when operation below
0°C is required. Table 2 lists the phone numbers of
these and other manufacturers.
______________________________________________________________________________________
Digitally Adjustable LCD Bias Supply
Input Bypass Capacitor
Output Filter Capacitor
Capacitors
The high value of the feedback resistor makes the feed-
back loop susceptible to phase lag if parasitic capaci-
tance is present at the FB pin. To compensate for this, it
may be necessary to connect a capacitor, C
parallel with R
required, the value of C
of R
ues range from 0pF to 220pF.
Due to high current levels and fast switching wave-
forms, proper PC board layout is essential. In particular,
keep all leads short, especially the lead connected to
the FB pin and those connecting Q1, L1, and D1
together. Mount the R
Use a star ground configuration: Connect the ground
lead of the input bypass capacitor, the output capaci-
tor, and the inductor at a common point next to the
GND pin of the MAX749. Additionally, connect the posi-
tive lead of the input bypass capacitor as close as pos-
sible to the V+ pin of the IC.
TRANSISTOR COUNT: 521;
SUBSTRATE CONNECTED TO GND.
___________________Chip Topography
CTRL
FB
ADJ
and on the individual circuit layout—typical val-
FB
V+
FB
(0.1178mm)
. Although C
0.070"
FB
PC Layout and Grounding
COMP
resistor very close to the IC.
GND
V+
Compensation Capacitor
depends upon the value
CS
COMP
is normally not
DLOW
DHI
(0.2032mm)
0.808"
COMP
, in
11