101-1157 Rabbit Semiconductor, 101-1157 Datasheet - Page 14

• Manufacturer Part Number: 101-1157
• Description: KIT DEVELOPMENT USA RCM4100
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 4000r
• Type: MPU Moduler

Specifications of 101-1157

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: Rabbit 4001
• Data Bus Width: 8 bit
• Interface Type: SPI
• For Use With/related Products: RCM4100
• Lead Free Status / RoHS Status: Lead free / RoHS compliant by exemption
• Other names: 316-1123

2.2.3 Step 3 — Connect Programming Cable
The programming cable connects the module to the PC running Dynamic C to download
programs and to monitor the module during debugging.
Connect the 10-pin connector of the programming cable labeled
the RCM4100 as shown in Figure 4. Be sure to orient the marked (usually red) edge of the
cable towards pin 1 of the connector. (Do not use the
normal serial connection.)
Depending on the programming cable, connect the other end to a COM port or a USB port
on your PC.
10
NOTE: Never disconnect the programming cable by pulling on the ribbon cable.
NOTE: Either a serial or a USB programming cable was supplied with this Development
Carefully pull on the connector to remove it from the header.
Kit. If you have a serial programming cable, an RS-232/USB converter (Rabbit Part
No. 20-151-0178) is available to allow you to use the serial programming cable with a
USB port.
Figure 4. Connect Programming Cable and Power Supply
DIAG
connector, which is used for a
PROG
RabbitCore RCM4100
to header J1 on