101-1157 Rabbit Semiconductor, 101-1157 Datasheet - Page 39

• Manufacturer Part Number: 101-1157
• Description: KIT DEVELOPMENT USA RCM4100
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 4000r
• Type: MPU Moduler

Specifications of 101-1157

• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: Rabbit 4001
• Data Bus Width: 8 bit
• Interface Type: SPI
• For Use With/related Products: RCM4100
• Lead Free Status / RoHS Status: Lead free / RoHS compliant by exemption
• Other names: 316-1123

4.2.2 Programming Port
The RCM4100 series of modules is programmed via the 10-pin header labeled J1. The
programming port uses the Rabbit 4000’s Serial Port A for communication. Dynamic C
uses the programming port to download and debug programs.
Serial Port A is also used for the following operations.
• Cold-boot the Rabbit 4000 on the RCM4100 series after a reset.
• Fast copy designated portions of flash memory from one Rabbit-based board (the
master) to another (the slave) using the Rabbit Cloning Board.
Alternate Uses of the Programming Port
All three clocked Serial Port A signals are available as
• a synchronous serial port
• an asynchronous serial port, with the clock line usable as a general CMOS I/O pin
The programming port may also be used as a serial port via the
connector on the
DIAG
programming cable.
In addition to Serial Port A, the Rabbit 4000 startup-mode (SMODE0, SMODE1), status,
and reset pins are available on the programming port.
The two startup mode pins determine what happens after a reset—the Rabbit 4000 is
either cold-booted or the program begins executing at address 0x0000.
The status pin is used by Dynamic C to determine whether a Rabbit microprocessor is
present. The status output has three different programmable functions:
1. It can be driven low on the first op code fetch cycle.
2. It can be driven low during an interrupt acknowledge cycle.
3. It can also serve as a general-purpose output.
Since the status pin is not used by the system once a program has been downloaded and is
running, the status pin can then be used as a general-purpose CMOS output.
The reset pin is an external input that is used to reset the Rabbit 4000.
Refer to the
for more information.
Rabbit 4000 Microprocessor User’s Manual
User’s Manual
35