FS-945 Digi International, FS-945 Datasheet - Page 18

• Manufacturer Part Number: FS-945
• Description: JTAG-BOOSTER FOR ELANSC400 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-945

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: AMD ElanSC400, SC410, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Sample File JTAGEL4.INI:
// Description file for AMD ÉlanSC400/ÉlanSC410
Target: Module FS FORTH-SYSTEME module ELAN486 on EVAELAN_2
// All chip select signals are set to output and inactive.
// All signals should be defined. Undefined signals are set to their defaults.
// Pin names are defined in upper case.
// Low active signals are signed with a trailing #.
// Group A: All pins in this group must be set to the same direction
GPIO21
GPIO22
GPIO23
GPIO24
GPIO25
GPIO26
GPIO27
GPIO28
GPIO29
GPIO30
GPIO31
// Group B: All pins in this group must be set to the same direction
SPKR
RTS#
SIROUT
DTR#
SOUT
RSTDRV
BL0#
GPIO19
GPIO18
GPIO17
// Group C: All pins in this group must be set to the same direction
//
//
GPIO16
GPIO15
GPIO_CS14
GPIO_CS13
GPIO_CS12
GPIO_CS11
18
This group is switched to output/active during programming of
Flash-EPROMs. (signals ROMRD# and ROMWR#)
Inp
Inp
Inp
Inp
Inp
Inp
Inp
Inp
Inp
Inp
Inp
Out,Hi
Out,Hi
Out,Lo
Out,Hi
Out,Lo
Out,Lo
Out,Hi
Out,Hi
Out,Lo
Out,Lo
Out,Hi
Out,Lo
Out,Lo
Out,Hi
Out,Hi
Out,Hi
// = PPDWE#
// = PPOEN#
// = SLCT
// = BUSY
// = ACK#
// = PE
// = ERROR#
// = INIT#
// = SLCTIN#
// = AFDT#
// = STRB#
//
//
//
//
//
//
// = CLK_IO
// = LBL2#
// = VPP2_B
// = VPP1_B
// = VCC_B
// = VPP2_A
// = VPP1_A
// = VCC_A
// = PDRQ0
// = PDACK0#
= WP_B#
= BVD2_B#
= BVD1_B#
= RDY_B#
= CD_B#
= REG_B#
= RST_B#
= MCEH_B#
= MCEL_B#
-> may control reset of FLASH!!
-> VCC ->???
-> VCC_B OFF
-> VPP2_A LOW
-> VPP1_A LOW
-> VCC_A OFF
-> !!!posible conflict!!!
JTAGEL4c.doc