FS-945 Digi International, FS-945 Datasheet - Page 29

• Manufacturer Part Number: FS-945
• Description: JTAG-BOOSTER FOR ELANSC400 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-945

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: AMD ElanSC400, SC410, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

/NOMAN
If you use a flash device which is identical to one of the supported parts, but is
from a different manufacturer, with this option you can suppress the comparison
of the manufacturer identification code. We recommend to use this option
together with the /DEVICE= option to avoid failures in autodetection.
/DEVICE-BASE=hhhhhh
Here you can specify a flash device starting address. In most cases, where the
flash device is selected with one of the CPUs chip select pins, this parameter is
not needed. But if there is any decoding logic in your hardware, this option will
be needed. Especially, if there are several flash banks connected to one chip
select and a sub decoding logic generates chip selects for these flash banks,
this option can be used to select a specific flash bank.
Default:
Abbreviation:
/OFFSET=hhhhhh
The programming starts at an offset of hhhhhh relative to the start address of
the flash device. If the offset is negative, the offset specifies an address relative
to the end of the flash device. See also option /TOP
Default:
Abbreviation:
/TOP
If the option /TOP is used the option /OFFSET= specifies the address where the
programming ends (plus one) instead of the starting address. This option is very
important for Intel CPU architectures, because target execution always starts at
the top of the address space.
/FILE-OFFSET=hhhhhh
If FILE-OFFSET is specified, the first hhhhhh bytes of the file are skipped and
not programmed to target.
Default:
Abbreviation:
1
JTAGEL4c.doc
hhhhhh=number base is hex
/DEVICE-BASE=0
/DB=
/OFFSET=0
/O=
/FILE-OFFSET=0
/FO=
1
29