FP-PROBE Fluke Electronics, FP-PROBE Datasheet - Page 20

• Manufacturer Part Number: FP-PROBE
• Description: PROBE FOR FOODPRO PLUS
• Manufacturer: Fluke Electronics
• Series: FoodPro Plusr
• Type: Temperature Prober

Specifications of FP-PROBE

• Usage: Liquids, Semi Solids
• Tip - Type: RTD
• Probe Temperature Range: -40 ~ 392°F (-40 ~ 200°C)
• Probe Length: 3.000" (76.20mm)
• Probe Material: Platinum
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Cable Length: -
• Plug Color: -
• Cable Insulation: -
• Plug Type: -
• Other names: 2477961

FoodPro Plus
Users Manual
Probe Replacement
The modular probe of the food safety thermometer is replaceable. To
replace probe, extend the probe partially to access the rubber caps.
Carefully pry up the rubber caps using a pin, and remove the screws using
a #2 cross-tip screwdriver as shown. Grasp the probe and carefully
separate the old probe from the probe base. Install the new probe in the
reverse order, firmly tightening the screws and replacing the rubber plugs.
The calibration accuracy of the unit is not affected by probe replacement
(Figure 14).
Battery Insertion and Replacement
To install a new 9V battery, remove the rubberized battery compartment
“plug” at the base of the unit by grasping the sides of the cover and pulling
straight out, exposing the battery. Gently shake or tap the base of the unit
on your palm to gain access to the battery. The 9V battery of the unit is
connected to the polarized snap connector (Figure 15).
16
Figure 15. Battery Insertion and Replacement
Figure 14. Probe Replacement
ebq17.eps
ebq18.eps