DF2239TF16I Renesas Electronics America, DF2239TF16I Datasheet - Page 787

• Manufacturer Part Number: DF2239TF16I
• Description: MCU 3V 384K I-TEMP 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2200r

Specifications of DF2239TF16I

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: I²C, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2239TF16I; HD64F2239TF16I

20.5.1
FLMCR1 is a register that makes the flash memory change to program mode, program-verify
mode, erase mode, or erase-verify mode. For details on register setting, refer to section 20.8, Flash
Memory Programming/Erasing.
Bit
7
6
5
4
3
Bit Name
FWE
SWE1
ESU1
PSU1
EV1
Flash Memory Control Register 1 (FLMCR1)
Initial Value R/W
—
0
0
0
0
R
R/W
R/W
R/W
R/W
Description
Flash Write Enable Bit
Reflects the input level at the FWE pin. It is set to 1 when
a low level is input to the FWE pin, and cleared to 0 when
a high level is input. When this bit is cleared to 0, the
flash memory changes to hardware protect mode.
Software Write Enable Bit
When this bit is set to 1, flash memory
programming/erasing is enabled. When this bit is cleared
to 0, bits 5 to 0 in FLMCR1 register and all EBR1 and
EBR2 bits cannot be set.
[Setting condition]
When FWE = 1
Erase Setup Bit
When this bit is set to 1, the flash memory changes to the
erase setup state. When it is cleared to 0, the erase
setup state is cancelled. Set this bit to 1 before setting
the E1 bit in FLMCR1.
[Setting condition]
When FWE = 1 and SWE1 = 1
Program Setup Bit
When this bit is set to 1, the flash memory changes to the
program setup state. When it is cleared to 0, the program
setup state is cancelled. Set this bit to 1 before setting
the P1 bit in FLMCR1.
[Setting condition]
When FWE = 1 and SWE1 = 1
Erase-Verify
When this bit is set to 1, the flash memory changes to
erase-verify mode. When it is cleared to 0, erase-verify
mode is cancelled.
[Setting condition]
When FWE = 1 and SWE1 = 1
Section 20 Flash Memory (F-ZTAT Version)
Rev. 6.00 Mar. 18, 2010 Page 725 of 982
REJ09B0054-0600