SDSCC-080G-000000 SanDisk, SDSCC-080G-000000 Datasheet - Page 9

• Manufacturer Part Number: SDSCC-080G-000000
• Description: SSD 2.5" SATA 80GB
• Manufacturer: SanDisk
• Series: SSD SATAr

Specifications of SDSCC-080G-000000

• Memory Size: 80GB
• Memory Type: FLASH - Nand
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: FFD-25-SATA-80-C-P; FFD-25-SATA-80-C-P

3.3.7.
The SSD requires input voltage of +5VDC, with a tolerance of 5% (4.75V-5.25V) and a
maximum ripple of 250 mV peak-to-peak. Table 3 describes the power consumption based on
Capacity. The power consumptions depend on the disk Capacity and the flash components being
used.
Note: The information in this section is relevant for SSD units with firmware version 1.03 and
3.3.8.
The SSD product life span and the performance are enhanced by the following features:




9
Disk Capacity
Dynamic wear-leveling algorithm: This algorithm guarantees the use of all flash blocks at
the same level of stress (write/erase cycle). The dynamic wear-leveling algorithm eliminates
situations where repeated writes to the same logical location cause flash block wear-out. The
dynamic wear-leveling algorithm functions by mapping logical blocks to physical blocks
(transparent to the customer application).
Garbage collection process: The garbage collection process eliminates the need to perform
erasure prior to every write, thus eliminating excessive disk deterioration.
EDC/ECC (Error Detection Code/Error Correction): The EDC/ECC extends disk
endurance by detecting and then fixing flash bits.
Bad-block mapping algorithm: This algorithm replaces bad blocks with new ones from
available spares.
Unformatted
later.
1 – 16
128
GB
Power Consumption
Endurance
Table 3: SSD Serial ATA 2.5” Typical Power Consumption
360
560
mA
Product Specification and User Manual
Idle Mode
1.80
2.80
W
460
690
mA
Read/Write Mode
SSD (Formerly FFD) Serial ATA 2.5"
42-PS-0605-00 Rev. 1.3
2.30
3.45
W