DVK-WLM400 Laird Technologies, DVK-WLM400 Datasheet - Page 25

• Manufacturer Part Number: DVK-WLM400
• Description: DEVELOPMENT KIT WISM+
• Manufacturer: Laird Technologies
• Type: Transceiverr

Specifications of DVK-WLM400

• Frequency: 2.4GHz
• Processor Series: WISM+
• Silicon Manufacturer: Laird Technologies
• Kit Application Type: Communication & Networking
• Application Sub Type: Wi-Fi Intelligent Serial
• Kit Contents: PCB, 2x Antennas, Power Adapter, USB Cable, RS-232
• Rohs Compliant: Yes
• For Use With/related Products: WLM400
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

5 Perform a Wireless Ping PCWISM+
The following section will walk you through the procedure of how to create an Ad-Hoc connection between a WISM+
Dev Kit and a wireless enabled PC in order to perform a wireless network Ping.
The WISM+ can operate either in infrastructure mode (communication with a Wireless Access Point or Router) or in
Ad-Hoc mode (with another WISM+, wireless PC in Ad-Hoc mode or any other 802.11b device capable of creating an
Ad-Hoc Connection). An Ad-Hoc mode connection is always 802.11b.
Launch WIF.exe using the USB connection, and then select the following…
Not “Bridged”
Now click “Configure”, and define the following Ad-Hoc static network connection as shown below…
The first access point table entry is the only entry in the table which can be used for an Ad-Hoc connection, and we
have set it up with an SSID of “Range Test” with a “Static” IP address of 192.168.1.22 & subnet mask 255.255.255.0.
Now click “OK” and then close WIF. Now, reset the WISM+ in order for the changes to be in effect.
© Laird Technology 2010
Version 1.00
WISM+ DVK MANUAL
Select “Ad-Hoc”
Page 20