SPBT2532C2.AT STMicroelectronics, SPBT2532C2.AT Datasheet - Page 30

• Manufacturer Part Number: SPBT2532C2.AT
• Description: IC BLUETOOTH VER 2.1 CLASS 2
• Manufacturer: STMicroelectronics

Specifications of SPBT2532C2.AT

• Frequency: 2.4GHz
• Data Rate - Maximum: 2Mbps
• Modulation Or Protocol: Bluetooth v2.1+EDR, Class 2 & 3
• Applications: General Purpose
• Power - Output: 2dBm
• Sensitivity: -85dBm
• Voltage - Supply: 2.8 V ~ 3.6 V
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 48kB RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2400 MHz to 2483.5 MHz
• Interface Type: I2C, I2S, SPI, UART
• Data Rate: 2 Mbps
• Modulation: AFH
• Operating Voltage: 2.8 V to 3.6 V
• Antenna: Without Antenna
• Board Size: 10 mm x 13 mm
• Operating Temperature Range: - 40 C to + 85 C
• Output Power: 4 mA
• Security: 128 bit Encryption
• Technology/ Type: Class 2 Bluetooth Module
• Processor Series: STLC2500
• For Use With: 497-10656 - BOARD DEMO BLUETOOTH SPBT2532C2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Bluetooth Devices
• Other names: 497-10539

Command description
D.6.2
D.7
D.7.1
Table 10.
D.8
D.8.1
D.8.2
30/50
GPIO_HostKeepAwake
HostDeepSleepEnable
GPIO_HostWakeup
Variable Name
Responses
If the change is accepted, the response is:
AT-AB Baudrate Changed
Config
The Config command is used to set a conflagration variable.
Syntax
AT+AB Config [variable name] = [variable value]
Following settings are supported through Config command
Config command
DefaultLocalName
The DefaultLocalName command is used to set the name of the device to the name that is
reported during device discoveries. By default, the abSerial interface uses "Amp'ed UP".
Changing the name using this command will permanently change the local name, unlike the
LocalName command.
Syntax
AT+AB DefaultLocalName [name]
Where [name] is a string for the new local name (up to 20 characters). The space character
is allowed; the name is assumed to be all text up to the end of the command.
Responses
If the operation is successful, the response is:
AT-AB LocalNameOk
none; [GPIO_number]
none; [GPIO_number]
(first value = default)
Possible Values
false; true
Doc ID 16089 Rev 7
Enables deep sleep mode
GPIO register used to prevent the module from
entering deep sleep mode. Suggested GPIO to use
are 2 or 3. A setting of none means that this function
is disabled
GPIO register used to wake up the module after it
enters deep sleep mode. Suggested GPIO to use are
2 or 3. A setting of none means that this function is
disabled
Description
SPBT2532C2.AT