SCP1000 PCB3 VTI Technologies, SCP1000 PCB3 Datasheet - Page 6
![SENSOR I2C 30-120KPA PCB](/photos/14/37/143738/scp1000_pcb3_sml.jpg)
SCP1000 PCB3
Manufacturer Part Number
SCP1000 PCB3
Description
SENSOR I2C 30-120KPA PCB
Manufacturer
VTI Technologies
Series
SCP1000r
Datasheet
1.SCP1000_PCB3.pdf
(37 pages)
Specifications of SCP1000 PCB3
Pressure Type
Absolute
Operating Pressure
4.35 ~ 17.40 PSI, 30 ~ 120 kPa
Output
Digital
Voltage - Supply
2.4 V ~ 3.3 V
Termination Style
Surface Mount
Operating Temperature
-20°C ~ 70°C
Package / Case
PCB Mount
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
551-1044
1.2.3
1.2.4
1.2.5
1.2.5.1
1.2.5.2
1.2.5.3
1.2.5.4
1.2.5.5
VTI Technologies Oy
www.vti.fi
Supported features
Operation
Factory calibration
High resolution measurement
High speed measurement
Ultra low power measurement
Low power measurement with external trigger
Temperature output
All sensors are factory calibrated. Some of the calibration parameters are: sensitivity to pressure,
offset, temperature sensitivity and temperature compensation. Calibration parameters will be read
automatically from the internal non-volatile during the start-up of the sensor.
SCP1000 different versions and supported features are presented in Table 1 below.
Table 1. SCP1000 versions.
The SCP1000 pressure sensor has 4 measurement modes plus standby and power down mode. In
all measurement modes, the pressure output word-length is 19 bits and the temperature output
word-length is 14
In the high-resolution measurement mode the pressure is measured continuously with the highest
resolution and the output data refresh rate is typically 1.8 Hz.
In the high speed measurement mode the measurements are performed continuously as well and
the conversion time is shortened at the cost of output resolution. This allows for an increase of the
output data refresh rate up approximately 9 Hz.
In the ultra low power measurement mode the device performs periodic measurements with the
lowest resolution (15 bits) and switches to standby mode between the measurements. In this mode
the updated pressure data is available approximately once per second.
In the low power measurement mode the device stays in standby mode and is ready to perform
single measurement using the selected resolution, 15 bits or 17 bits. After the measurement is
complete and the output data is refreshed, the sensor switches back to standby mode. Average
current consumption in low power mode depends on measurement resolution and trigger
frequency.
Temperature information is available in every measurement mode for each pressure measurement.
1
typical value in high resolution measurement mode
Features
Supply voltage
Measuring range
Resolution
Interface
Temperature output
Clock
Marking on top of
component
1
bits.
SCP1000-D01
30 kPa – 120kPa
SPI max 500 kHz
2.4 V – 3.3 V
Internal
1.5 Pa
D01
Yes
Doc.Nr. 8260800.08
Subject to changes
SCP1000-D11
TWI max 400 kHz
30 kPa – 120kPa
2.4 V – 3.3 V
Internal
1.5 Pa
D11
Yes
SCP1000 Series
Rev.0.08
6/37