IS-CL01-F-E NKK Switches, IS-CL01-F-E Datasheet - Page 24

• Manufacturer Part Number: IS-CL01-F-E
• Description: SMARTSWITCH CONTROLLER OLED
• Manufacturer: NKK Switches

Specifications of IS-CL01-F-E

• Accessory Type: Controller
• Description/function: SMARTSWITCH Development Kit
• For Use With/related Products: OLED SmartSwitch™
• For Use With: 360-2344 - SWITCH OLED 64RGB X 48
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 360-2424

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
7. Key Terms & Definitions
OLED module
Host
Controller
Logic Board
Byte
Nibble/Hex digit
ASCII
Communication
Format
Address
8. Firmware issues
The problems found in the most current version are listed below and get resolved in the following version.
Version V1.4
CL01 Intelligent Controller Users Manual B.doc
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
CL01 Intelligent Controller Users Manual
NKK Switches’ OLED SmartSwitches and SmartDisplays.
Any computer, terminal, or other device that can communicate over the
RS232 line.
A PCB assembly that controls one or more logic boards and the switches
associated with them. It communicates with a host over the RS232 line.
A PCB assembly with “glue logic” for mounting switches. It is controlled by a
controller.
An eight bit hex value ranging from 00H to FFH (Decimal 0 to 255). The bit
format of a byte is: (B7 B6 B5 B4 B3 B2 B1 B0) where B7 is most significant
and bit B0 is least significant bit.
A four bit value ranging from 0H to FH. A byte consists of two nibbles.
A byte value representing a symbol.
There are two formats to transmit a byte:
1. Hex format - A hex byte is transmitted without any change to it. [xxH] will
2. ASCII HEX format - Each nibble of the byte is converted to ASCII code
A two byte value ranging from 0001H to FFFFH representing the 65536
memory locations for pictures and attributes on microSD flash.
No firmware issues at this time.
be used to denote this.
All commands and some data are sent by using this format.
and sent as a byte. [xxAH] will be used to denote this.
For example, the hex byte 5AH is transmitted in two bytes, 35H and 41H.
The ASCII value for 5 is 35H and the ASCII value for A is 41H.
All addresses and most data are sent using this format.
www.nkkswitches.com • Email [e-mail]
Page 24 of 24
0110