IS-CL01-F-E NKK Switches, IS-CL01-F-E Datasheet - Page 9

• Manufacturer Part Number: IS-CL01-F-E
• Description: SMARTSWITCH CONTROLLER OLED
• Manufacturer: NKK Switches

Specifications of IS-CL01-F-E

• Accessory Type: Controller
• Description/function: SMARTSWITCH Development Kit
• For Use With/related Products: OLED SmartSwitch™
• For Use With: 360-2344 - SWITCH OLED 64RGB X 48
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 360-2424

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
Step 6C: If timer for switch 1 expires then:
CL01 Intelligent Controller Users Manual B.doc
4. If switch 2 action address for switch 2 is not equal zero and the attribute for the location is
5. If switch 2 action address for switch 2 is equal zero or the attribute for the location is not
1. Transmit 83H to host if flag is enabled.
2. Increment current address for switch 1.
3. If current address for switch 1 is not equal ((end address for switch 1) +1) then:
4. If current address for switch 1 is equal ((end address for switch 1) +1) then:
programmed then:
e. Start address for switch 2 = switch 2 action address for switch 2.
f. Current address for switch 2 = switch 2 action address for switch 2.
g. Get the attributes and put the values for switch 2 action address for switch 1, switch 2 action
h. Set update flag for switch 2.
programmed then take no action.
i. Transmit FDH and current address for switch 1 to host if flag is enabled.
j. Set update flag for switch 1.
k. Read the Attributes for end address location.
address for switch 2, end address for switch 2 and timers for switch 2.
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
iii. If end location action address for switch 2 is equal zero then take no action.
iv. If end location action address for switch 2 is not equal zero then:
ii. If end location action address for switch 1 is not equal zero then:
i. If end location action address for switch 1 is equal zero then put current address = start
address and set update flag for switch 1.
CL01 Intelligent Controller Users Manual
1. Start address for switch 1 = end address action address for switch 1.
2. Current address for switch 1 = end address action address for switch 1.
3. Get the attributes and put the values for switch 1 action address for switch 1,
4. Set update flag for switch 1.
1. Start address for switch 2 = end address action address for switch 2.
2. Current address for switch 2 = end address action address for switch 2.
3. Get the attributes and put the values for switch 2 action address for switch1,
4. Set update flag for switch 2.
switch 1 action address for switch 2, end address for switch 1 and timers for
switch 1.
switch 2 action address for switch 2, end address for switch 2 and timers for
switch 2.
www.nkkswitches.com • Email [e-mail]
Page 9 of 24
0110