IS-L0102-IS15ABCP4CF NKK Switches, IS-L0102-IS15ABCP4CF Datasheet - Page 11

• Manufacturer Part Number: IS-L0102-IS15ABCP4CF
• Description: BOARD LOGIC IS15ABCP4CF & AT548
• Manufacturer: NKK Switches

Specifications of IS-L0102-IS15ABCP4CF

• Accessory Type: Logic Board
• For Use With/related Products: Standard SmartSwitch™
• For Use With: 360-2330 - SMARTSWITCH STD RED/GRN LED
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
Command to set LCD/LED codes for all 16 Modules
[LCD/LED code block] is 16 bytes of LCD/LED data, one for each Module, and must be sent in ASCII HEX
format.
This command sets the 16 LCD/LED codes in the LCD/LED refresh buffer. If the value of a LCD/LED code
is zero, the corresponding code in the refresh buffer is left unchanged. If an update is desired for the value of
zero, Bit 7 should be set to 1.
Command to download one LCD/LED Code to specified Module
[Module #] is one byte with value of 01H to 10H and must be sent in ASCII HEX format.
[LCD/LED code] is one byte with value of 01H to FFH and must be sent in ASCII HEX format.
Command to download a Legend block
[Address] is one byte with value of 01H to FFH and must be sent in ASCII HEX format.
[Legend Block] is 125 bytes and must be sent in ASCII HEX format.
The LCD/LED code is not transferred to LCD/LED code refresh block.
Command to clear the Image data at a specified Address
[Address] is one byte with value of 01H to FFH and must be sent in ASCII HEX format.
[00H] is two byte and must be sent in ASCII HEX format (30 30).
Command to fill the Image data at a specified Address
IS-C1603 Intelligent Controller Users Manual C.doc
3. Commands to download the pictures, LCD/LED codes and control codes.
This command sets the 16 LCD/LED codes.
This command sets the LCD/LED code for specified module.
This command downloads a Legend Block from the host to the EEPROM location.
This command sets all the bits in the image data at a specified Address to zero (off).
This command sets all the bits in the image data at a specified Address to one (on).
command format: 2CH
transmit format:
command format: 2FH
transmit format:
command format:
transmit format:
command format:
transmit format:
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
(xxH) (xxH)
(xxH) (xxH)
(xxH)
(xxH)
28H
27H
IS-C1603 Intelligent Controller Users
www.nkkswitches.com • Email [e-mail]
[Address] [Legend Block]
[Address]
30H
30H
(xxAH)
(xxAH)
[LCD/LED code block]
[Module #] [LCD/LED code]
(xxAH)
(xxAH)
[00H]
(xxAH)
(xxAH)
Manual
(xxAH)
Page 11 of 45
0110