IS-L0102-IS15ABCP4CF NKK Switches, IS-L0102-IS15ABCP4CF Datasheet - Page 9

• Manufacturer Part Number: IS-L0102-IS15ABCP4CF
• Description: BOARD LOGIC IS15ABCP4CF & AT548
• Manufacturer: NKK Switches

Specifications of IS-L0102-IS15ABCP4CF

• Accessory Type: Logic Board
• For Use With/related Products: Standard SmartSwitch™
• For Use With: 360-2330 - SMARTSWITCH STD RED/GRN LED
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
Commands to the controller
Command to reboot the controller
Command to check communication
Command to upload a Legend Block
[Address] is one byte with value of 01H to FFH and must be sent in ASCII HEX format.
The controller transmits back the image, 125 bytes in standard resolution mode, in HEX format.
Command to upload the Pointer values of all 16 Modules
Command to upload Pointer value at specified Module
[Module #] is one byte with value of 01H to 10H and must be sent in ASCII hex format.
1. Commands that do not alter the data in the memory addresses:
The command reboots the controller to power-up state.
The command is used to check if the controller is on-line.
The controller transmits back 61H to the host.
IS-C1603 Intelligent Controller Users Manual C.doc
This command uploads a Legend block from the EEPROM location to the host.
This command uploads the Pointer values in ASCII HEX format.
This command uploads the Pointer value in ASCII HEX format.
command format:
transmit format:
command format:
transmit format:
command format:
transmit format:
command format: 2DH
transmit format:
command format: 2EH
transmit format:
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
(xxH)
(xxH) (xxH)
(xxH) (xxH)
29H
IS-C1603 Intelligent Controller Users
(xxH)
(xxH)
24H
01H
www.nkkswitches.com • Email [e-mail]
[Address]
52H
52H
(xxAH)
[Module #]
(xxAH)
Manual
Page 9 of 45
0110