IS-L0102-IS15ABCP4CF NKK Switches, IS-L0102-IS15ABCP4CF Datasheet - Page 21

• Manufacturer Part Number: IS-L0102-IS15ABCP4CF
• Description: BOARD LOGIC IS15ABCP4CF & AT548
• Manufacturer: NKK Switches

Specifications of IS-L0102-IS15ABCP4CF

• Accessory Type: Logic Board
• For Use With/related Products: Standard SmartSwitch™
• For Use With: 360-2330 - SMARTSWITCH STD RED/GRN LED
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
[Option] = EEH (45 45)
[Option] = EFH (45 46)
[Option] = EDH (45 44)
[Flag Byte] is one byte and must be sent twice in ASCII HEX format. This command writes the downloaded
flag data to storage memory. The changes go into effect after the following power up / reboot.
Flag Byte A bit settings:
B0=0 ---> No transmission.
B0=1 ---> Upon switch release, transmit one byte (B0H+switch number).
B1=0 ---> No transmission.
B1=1 ---> Upon switch press, transmit one byte (80H+switch number).
B2=0 ---> No transmission.
B2=1 ---> Upon switch press, transmit from the user-defined switch press event data. Up to 16 bytes or until a
IS-C1603 Intelligent Controller Users Manual C.doc
This command sets a flag which controls the features of the controller.
B0
B1
B2
B3
B4
B5
B6
B7
Bit
command format:
transmit format:
Flag Byte A Default Value=63H
byte value is 00H.
Enable
Value
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
1
1
1
1
1
1
1
1
Default Switch release report
Default Switch press event report
User-defined Switch press event
report
Default Image press event report
User-defined Image press event
report
Execute Attribute for Switch
press/release event enable
Switch press event beep enable
Animated Images operation mode
enable
(xxH) (xxAH)
21H
IS-C1603 Intelligent Controller Users
Flag Byte A
Flag Byte B
Flag Byte C
www.nkkswitches.com • Email [e-mail]
[Option] [Flag Byte] [Flag Byte]
Flag
(Flag-A)
(Flag-B)
(Flag-C)
(xxAH)
Manual
Reports switch release events (Module # +
B0H) in XXH format.
Reports switch press events (Module # +
B0H) in XXH format.
Transmits user-defined data for that switch
upon switch press event in XXH format.
Transmits Pointer value upon switch press
event in XXAH format.
Transmits user-defined data for that Image
upon Image press event in XXH format.
Executes viewing angle/brightness code
and updates pending Pointer values if non-
zero.
Provides audio feedback through the audio
connector upon any switch press event.
Fills/clears displays and changes
backlighting colors upon power-up or
reset.
(xxAH)
Controller action when flag is set
Page 21 of 45
0110