XR18W750IL48-F Exar Corporation, XR18W750IL48-F Datasheet - Page 23

• Manufacturer Part Number: XR18W750IL48-F
• Description: IC WIRELESS UART CTRLR 48QFN
• Manufacturer: Exar Corporation

Specifications of XR18W750IL48-F

• Package / Case: 48-VFQFN Exposed Pad
• Function: Controller
• Rf Type: General Purpose
• Secondary Attributes: I²C Interface
• Processor Series: XR18W750
• Core: 8051
• Data Bus Width: 8 bit
• Data Ram Size: 32 KB
• Interface Type: I2C, UART
• Maximum Clock Frequency: 400 KHz
• Number Of Timers: 1
• Operating Supply Voltage: 2.25 V to 3.63 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: PK51, CA51, A51, ULINK2
• Development Tools By Supplier: XR18W750/753-0A-EB, XR18W750/753-0B-EB
• Minimum Operating Temperature: - 40 C
• Program Memory Type: EEPROM
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

REV. 1.0.0
ISR[0]: Interrupt Status
•
•
ISR[3:1]: Interrupt Status
These bits indicate the source for a pending interrupt at interrupt priority levels (See Interrupt Source
ISR[4]: Reserved
ISR[5]: RTS#/CTS# Interrupt Status
This bit is enabled when EFR bit-4 is set to a logic 1. ISR bit-5 indicates that the CTS# or RTS# has been de-
asserted.
ISR[7:6]: FIFO Enable Status
These bits are set to a logic 0 when the FIFOs are disabled. They are set to a logic 1 when the FIFOs are
enabled.
This register is used to enable the FIFOs, clear the FIFOs, set the transmit/receive FIFO trigger levels, and
select the DMA mode. The DMA, and FIFO modes are defined as follows:
FCR[0]: TX and RX FIFO Enable
•
•
FCR[1]: RX FIFO Reset
This bit is only active when FCR bit-0 is a ‘1’.
•
•
5.5
Logic 0 = An interrupt is pending and the ISR contents may be used as a pointer to the appropriate interrupt
service routine.
Logic 1 = No interrupt pending (default condition).
Logic 0 = Disable the transmit and receive FIFO (default).
Logic 1 = Enable the transmit and receive FIFOs. This bit must be set to logic 1 when other FCR bits are
written or they will not be programmed.
Logic 0 = No receive FIFO reset (default)
Logic 1 = Reset the receive FIFO pointers and FIFO level counter logic (the receive shift register is not
cleared or altered). This bit will return to a logic 0 after resetting the FIFO.
FIFO Control Register (FCR) - Write-Only
23
WIRELESS UART CONTROLLER
XR18W750
Table
9).