M1AFS-ADV-DEV-KIT-PWR Actel, M1AFS-ADV-DEV-KIT-PWR Datasheet - Page 11

• Manufacturer Part Number: M1AFS-ADV-DEV-KIT-PWR
• Description: MCU, MPU & DSP Development Tools Fusion Advanced Dev Kit w/ Power
• Manufacturer: Actel

Specifications of M1AFS-ADV-DEV-KIT-PWR

• Processor To Be Evaluated: M1AFS1500-FGG484
• Interface Type: Ethernet, USB, I2C, UART
• Operating Supply Voltage: 1.5 V to 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Installation and Settings
Software Installation
Hardware Installation
Jumper and Switch Settings
Fusion Advanced Development Kit User’s Guide
Download and install the latest release of Libero IDE from the Actel website and register for your free Gold license. For
instructions on how to install Libero IDE and SoftConsole, refer to the Libero IDE Installation and Licensing Guide,
available on the Actel website: www.actel.com/documents/install_ug.pdf.
The FlashPro3 programmer is built into the low-cost programming stick (LCPS) and plugs directly into the FADK
board. The USB 2.0 high-speed cable plugs into the LCPS to allow the M1AFS1500 device to be programmed.
Recommended default jumper settings are defined in
default settings to enable the pre-programmed demonstration design to function correctly.
Jumper
JP10
JP17
JP18
JP20
JP21
JP22
JP23
JP24
Jumper to select either 1.5 V external regulator or Fusion 1.5 V internal
regulator.
Pin 1–2 = 1.5 V internal
Pin 3–2 = 1.5 V external
Analog temperature out (AT0) to analog temperature return
(ATRNT0)
Jumper to select TRST High or Low.
Pin 1–2 = High (V3P3_AFS)
Pin 2–3 = Low (GND)
Power sequencing for 10 V rail
1–2: Use a reset chip to provide 100 ms delay on the 10 V rail
2–3: Use Fusion gate drivers to provide 100 ms delay on the 10 V rail
OLED_BS1
1–2: V3P3
2–3: GND
OLED_BS1
1–2: V3P3
2–3: GND
V
V
JTAG
PUMP
Table 1-1 · Fusion Advanced Development Kit Jumper Settings
to V3P3_AFS
to V3P3_AFS
Function
Table 1-1
and
Table 1-2 on page
12. Connect the jumpers with the
Header to external
temperature monitor
diode
Default Setting
Pin 3–2
Pin 2–3
Pin 1–2
Pin 2–3
Pin 1–2
Pin 1–2
Pin 1–2
1
11