FPMR12TR7508NA Fujitsu, FPMR12TR7508NA Datasheet - Page 5

DC/DC Converters & Regulators 8A Neg SIP 6-14VIn .7525-5V Out

FPMR12TR7508NA

Manufacturer Part Number
FPMR12TR7508NA
Description
DC/DC Converters & Regulators 8A Neg SIP 6-14VIn .7525-5V Out
Manufacturer
Fujitsu
Datasheet

Specifications of FPMR12TR7508NA

Output Power
40 W
Input Voltage Range
6 V to 14 V
Output Voltage (channel 1)
0.7525 V to 5 V
Output Current (channel 1)
8 A
Package / Case Size
SIP
Product
Non-Isolated / POL
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
FPMR12TR7508*A
6-14Vdc Input, 8A, 0.7525-5.5Vdc Output
http://www.fdk.co.jp
Operation
Input and Output Impedance
The
connected to a DC power source using a low
impedance input line. In order to counteract the
possible effect of input line inductance on the stability
of the converter, the use of decoupling capacitors
placed in close proximity to the converter input pins is
recommended. This will ensure stability of the
converter and reduce input ripple voltage. Although
low ESR Tantalum or other capacitors should typically
be adequate, very low ESR capacitors (ceramic, over
100µF) are recommended to minimize input ripple
voltage. The converter itself has on-board internal
input capacitance of 3µF with very low ESR (ceramic).
FPMR12SR7508*Aと入力電源間は低インピーダンスで接続してください。コン
バータの安定性に影響のある入力インダクタンスを抑えるため、コンバータの入
力ピンの近傍にデカップリングコンデンサを付加することをお勧めします。これに
よりコンバータの安定動作を確実にし、入力リップル電圧を抑制します。低
ESRタンタル、又はその他のコンデンサも一般的には問題ありませんが、入力
リップルを最小にするためには、非常に低ESRコンデンサ(セラミックで100μF以
上)を推奨します。コンバータ自身は入力回路に極低ESRの3μFセラミック入力
コンデンサを搭載しています。
The FPMR12SR7508*A is capable of stable operation
with no external capacitance on the output. To
minimize output ripple voltage, the use of very low
ESR ceramic capacitors is recommended. These
capacitors should placed in close proximity to the load
to improve transient performance and to decrease
output voltage ripple.
FPMR12SR7508*Aは出力に外付けコンデンサが無い状態でも安定して動
作します。出力リップルを最小にするため、極低ESRのセラミックコンデンサの接
続を推奨します。過渡時の特性向上と出力リップル低減のために負荷の
近傍に極低ESRセラミックコンデンサを実装することをお勧めします。
Note that the converter does not have a SENSE pin to
counteract voltage drops between the output pins and
the load. The impedance of the line from the converter
output to the load should thus be kept as low as
possible to maintain good load regulation.
このコンバータは出力端子と負荷間の電圧ドロップを補正するセンス端子を設
けていません。精度の高い負荷特性を保持するために、コンバータの出力
から負荷までのラインインピーダンスは可能な限り低くしてください。
FPMR12SR7508*A
Delivering Next Generation Technology
converter
should
be
Page 5 of 26
ON/OFF (Pin 5)
The ON/OFF pin (pin 5) can be used to turn the
converter on or off remotely using a signal that is
referenced to GND (pin 3), as shown in Fig. A.
Two
corresponding to negative and positive logic. In the
negative logic option, to turn the converter on Pin 5
should be at logic low or left open, and to turn the
converter off Pin 5 should be at logic high or connected
to Vin. In the positive logic option, to turn the converter
on Pin 5 should be at logic high, connected to Vin or left
open, and to turn the converter off Pin 5 should be at
logic low.
ON/OFF端子(5番ピン)は図Aのように、グランド(3番ピン)を基準としたリモート
信号によりコンバータをON/OFFするのに使われます。 ネガティブとポジティブロ
ジックに対応するため、2種類のリモートコントロールを選択可能です。
ネガティブオプションの場合、コンバータをONするには5番ピンをLowレベル、又は
未接続とし、コンバータをOFFするには5番ピンをHighレベル、又はVinと接続
とします。ポジティブオプションの場合、コンバータをONするには5番ピンをHighレ
ベル、Vinに接続、又は未接続とし、コンバータをOFFするには5番ピンをLowレ
ベルにします。
Pin 5 is internally pulled-down. A TTL or CMOS logic
gate, or
used to drive Pin 5. When using an open collector/
drain transistor, a pull-up resistor, R*=75kΩ, should
be connected to Vin (See Fig.A).
The device driving Pin 5 must be capable of:
(a) Sinking up to 0.2mA at low logic level (≦0.8V)
(b) Sourcing up to 0.25mA at high logic level (2.3–5V)
(c) Sourcing up to 0.75mA when connected to Vin
ON/OFFピンはモジュール内部でプルダウンされています。TTL、 CMOSロジッ
ク、又はオープンコレクタのトランジスタもON/OFFピンの操作に使用可能です。
オープンコレクタのトランジスタを使用する時は図Aに示す75kΩ程度のプルアップ
抵抗をVinに接続してください。(図A参照)
ON/OFFピンを操作するデバイスには下記能力が必要です。
(a) 0.8V以下のLowレベルで0.2mAまでのシンク能力
(b) 2.3V-5VのHighロジックレベルで0.25mAまでの供給能力
(c) Vin接続時には0.75mAまでの供給能力
Vin
Control Signal
Fig. A: Circuit configuration for remote ON/OFF
remote
R*
an open collector/drain transistor can be
control
Vin
On/Off
GND
options
Ver 2.3 Aug. 31, 2007
Vout
TRIM
are
Series
available,
Load

Related parts for FPMR12TR7508NA